How to change filters in Culligan's Aqua Cleer Reverse Osmosis System

[@RPDBY]

Why did you skip the RO filter change? there is a hose at the bottom of the filter, which makes it more difficult to change, but that was totally ignored

[@iamzombie76]

So... Hypothetically speaking, if a person neglected to close the valve to the tank & changed out the filters (hypothetically spraying water all over the room) how would you go about refilling the tank once everything is reassembled?

[@matthewshelton1403]

😂😂😂

[@GregMN1]

Please go over the Capillary tube. What happens if you forget it until the end? Water back on now. Also show how to remove the tubes from the final filter. Mine is in the back of the cabinet and can’t push in and pull out… easy on the new one with no tube. 😅😢

[@derekbottorff2249]

Where in the world do I buy these filters?? I can’t find them anywhere.

[@davesteigerwald4474]

I have the same question. Any luck on your end?

[@ValerieAlexandra]

i have only found them at a culligan franchised owned store

[@James-rg2wd]

Culligan is the only place I found them and the RO filter is pricey.

[@The_Brickishaw]

Only by calling your local Culligan retailer.

[@bluesky5587]

the big filter at the end has a tube coming out of it at the back that drains water out..why did you not cover that? the first ones are easy ...I would like to see how to properly change the end one with the tube attached. thank you

[@elizabethaguilar2183]

I can’t find these filters anywhere where is the best place to buy them or anything similar thank you

[@davesteigerwald4474]

I have the same question. Any luck on your end?

[@davesteigerwald4474]

where do I buy those?

[@johndeer5524]

I did everything you said and went to get water this morning and the tank is empty there's no water. I am going to let it drip for 30 minutes but I only added a mineral filter. I did forget to turn the second valve off so I'm guessing it could have created pressure?

[@joeyhukin997]

can anyone share a link for the exact replacement filters? Having trouble finding the right ones

[@matthewshelton1403]

You need to order them through your local culligan

[@GarbagemanTg]

Just wondering how you would disinfect the system?

[@isingsculliganwater]

Usually, it's not necessary to disinfect the system. Do you have a situation where you think your system was contaminated?

[@sherylgullickson6618]

Do I turn the system OFF for the tank to pressurize?

[@The_Brickishaw]

Upvote

[@bmartin1785]

Followed these instructions to a ‘T’ and now the holding tank won’t fill with water and there’s extremely low pressure at the tap 🤦‍♂️

[@The_Brickishaw]

Upvote

[@paulzickler4736]

The post filter does not do,what you say it does. Your only description was “ya put the new one in.” When I did that, it leaked like crazy. You don’t explain how to connect the hose to the filter. The ring on the new filter does nothing. Super frustrating

[@isingsculliganwater]

Did it leak from the filter or the hose? You shouldn't need to disconnect the hose to change the filter, and the filter should snap right in.

[@robertdurand6809]

You didn't address the most critical component...RA filter. Getting its plug out doesn’t seem to work. So the whole system goes down. My system is more than 15 yrs old. Original RA element. Near zero flow. e