How to change front brake discs / front brake rotors on CITROEN C1 (PM, PN) [TUTORIAL AUTODOC]

[@the1beard]

There's a question over the 65NM Caliper torque setting . some believe it should be 90NM ? and the Wheel nuts 100NM not 120NM ??

[@RantAndRave30]

I don’t understand this need for copper grease, all I can see happening to that copper grease you spray on the disk is it will go by centrifugal force flying off into the contact area of the disks and pads. 😮

[@sund5]

Very very nice video! No bullshit! :-)

[@benyao5353]

Wouldn’t you need to bleed the breaks after?

[@RantAndRave30]

No not at all, you should check the fluid level is still correct but no need to bleed as no air will get in the system

[@aqim5347]

How to replace rear bumper of naza carnival 2010?? Help me out

[@autodocuk]

Thank you for your comment. Unfortunately, we can’t recommend any installation method, a detailed manual can be found in the service documentation for the repair of your car. Best Regards, Autodoc team.

[@mrbeatsdj9917]

A great video, thank you.

[@charlieself]

5nm for disc T30 screw. 89nm for the caliper bracket. 30nm for the caliper pin bolts 100nm fot the wheel nut lugs

[@autodocuk]

We're sure your comment will be helpful to many of our viewers.

[@alexey9900]

Good 👍👍👍

[@ericguichard9417]

Je mets un pouce bleu mais le serrage des roues sur une C1 c'est 103 Nm, support d'étrier 88Nm, étrier 30 Nm, vis torx qui tient le disque 5 N.m. où trouvez-vous vos serrages ? 😟

[@lourencoandradeesousa4782]

The music is awful. Please do these videos without music. Its so mutch more pleasent with only the tools noises. Cheeres Good video anyway.

[@autodocuk]

Thank you for your attention to our videos. We will make the necessary changes as soon as possible. AUTODOC

[@grumpyfishes]

Yes, please do without all that racket!