How to change Modes on your Spektrum NX Transmitter

[@JimmyDsRC]

Much easier than it used to be. De-soldering, re-wiring, re-soldering, moving ratchets and springs... This is so much better. Great video, thanks!

[@larryhawkes1347]

Thanks for the video, I have a new nx8 on the way and was reading how to make these types of adjustments and this video helped make things more clear. In the manual on Page 6 transmitter functions, item 10 and 28 says mode change screw. Can you explain the purpose of those screws? Thanks

[@basdebruijn1236]

Thx

[@hectorromero2744]

Hello Friend how are you? I want to thank you very much for your video, it is very very specific in what I wanted to know and how easy this spectrom transmitter is to make these adjustments without having to open it and damage a circuit. Thank you for this video that you have uploaded and much success on your channel

[@norbertosthues6513]

Hello, you did not say anything about the gimbel travel limit. On my system mode 2 this gimbel travel limit is preset for gas left. I would like to switch it off and put it on the right side for mode 1. Does this travel limit affect calibration? Does this have to be done before calibrating the gimbals?

[@Cosme422]

I want my left throttle stick to be in full throttle when I pull it down and stop my throttle when I push it up. What is the best way to do that?

[@martinj9251]

Hi I have a Nx8, what mode do I need to be in for left stick throttle & elevator & right stick for rudder, as there all around the Incorrect way at present 🙄

[@darnmg]

You forgot to change the switches under the little rubber flaps to change the travel distance.

[@AustinPetDetective]

Nice and easy I don’t think so. I would rather wait and get a radio were I don’t have to attack it with a screwdriver, no matter how easy you make it.