On the press it is backwards but assembled it is correct???
@Gear1993Head Жыл бұрын
@@jamesu the race is supposed to go into the axle housing and bearing is pressed onto the axle itself. Im not rewatching video but from what I remember when I seen this he did it the oppostie. Will still work but its wrong.
@chownzi24613 ай бұрын
It is I saw that
@gavin18983 жыл бұрын
What were the parts used? I have an 08 Titan SE and I’m looking to change my bearings and seals but can’t seem to find what part #’s for the 08-newer Titans
@arisaquino523910 ай бұрын
good video, thanks for sharing, sorry for a question, does the bearing have grease or does it work with differential oil?
@wess-cp7vd Жыл бұрын
Not exsaxtly Step by step 😁
@techep3Ай бұрын
Slide hammers suck, they are so painful to use.
@alanpaz20098 ай бұрын
Nice video . How much do you charge for that job.?? I have same problem same car
@charlesharris810711 ай бұрын
what if the race is stuck in the differential housing ive slide hammered mine cant get it come out.
@Bobcatz18703 жыл бұрын
Well done video. Answers a lot of my question and increases my confidence that i can pull this off (pun intended). This is on my agenda in the next couple of weeks. Couple of questions…did you seat the race for the bearing before final assembly? What part of the hub assembly did you have to heat up to get it out with the slide hammer? Face with studs in it or the axle tube? Thanks again for taking the time to make the video!
@billgoatgarage3 жыл бұрын
I heated the diff housing where the seal would be located and yes I seated the race before sliding the whole assembly in
@richardharnden3043 жыл бұрын
Put a new vent on the rear axle that’s why the seal blows out.
@No_Offense_Brah2 жыл бұрын
My driver side will not come out. I've moved up to a 20 lb slide hammer. Still nothing. All bolts removed. Is their something inside the housing on the diff holding it on?
@billgoatgarage2 жыл бұрын
no it's just the seal and rust holding it together. have you tried applying some heat to soften the seal? I had to heat it to get mine apart
@No_Offense_Brah2 жыл бұрын
@@billgoatgarage just got it. It's nap time now lol
@No_Offense_Brah2 жыл бұрын
@@billgoatgarage 2nd question that race has barely any lip on it to get a puller on it. Any advice?
@billgoatgarage2 жыл бұрын
to pull the old bearing off? just cut it like I showed
@No_Offense_Brah2 жыл бұрын
@@billgoatgarage no it's inside the housing. I ordered the complete axle with bearings already pressed on.