Thanks for the vid. Would recommend getting a lump hammer and rubber mallet for removing parts in the future. And longer handles for your sockets to use leverage to preserve your wrist over the years! Handy for you to how you did it. Cheers
@gazza99196 ай бұрын
Thanks for your comment. Thankfully since I have done this video I've had a decent equipment upgrade and now have quality tools. Its crazy what a bit of length can do. (That sounds really bad 🤣)
@JohnSmith-el5mo3 жыл бұрын
Mine is drum disc at the back. Lucky you.
@gasgiant71225 ай бұрын
Omg now many armchair mechanics can you have in one comments section, jeez, give him a break. Good video what model is that focus as my 09 1600 petrol has drums?
@gazza99195 ай бұрын
Thanks mate, it's a 58 plate 1.8 deisel
@Mike0200000000Ай бұрын
I couldn't remove the disc, it was stuck. Is it even allowed to hammer that hard?
@gazza9919Ай бұрын
They are sometimes a nightmare and you have to release all your demons on the disc with the hammer
@jahcrispie76763 жыл бұрын
Good informative video mate. In future use silicone grease on the slide pins as copper grease can cause the rubber boots that they slot into to deteriorate quicker.
@gazza99193 жыл бұрын
Thanks for the advice. I shall bare this in mind for the future 😃
@jahcrispie76763 жыл бұрын
@@gazza9919 No worries :D
@frommyphone955811 ай бұрын
Great job! But...a rong information 😑. Don't made emergency stop whit new disc brake!!😢 Will be damage! 😂 Red the instructions manual! 🎉
@gazza991911 ай бұрын
I've never had a problem with it personally and I've done a good few in my time
@bythesea2784 Жыл бұрын
What tools you are useing nothing
@gazza9919 Жыл бұрын
You will just need a torx set and a piston reset tool