Quick video on how to change the oil on a suzuki LTR 450
Пікірлер: 22
@L00se_change Жыл бұрын
Yeah brother thank you for the commentary
@SkillinTime Жыл бұрын
Ur welcome thanks for watchING
@Jason-zr6il3 ай бұрын
Is the clutch side connected to oil reservoir tank? When I fill my clutch up the oil reservoir level rises. I don’t get it because I would think they are isolated from each other.
@jimmypalumbo9932 Жыл бұрын
Where did you find those little Allen key bolts ?
@ericdavid89011 ай бұрын
I didn't find the second allen bolt. There was a 10mm bolt towards the front, right in the middle that was pointed out in another video. The first driver side allen bolt I did find however. I will say that 1200 and 400 didn't fill it up for me. Once I filled it and let the engine run for a few secs, I was not getting anything on the dip stick. I put another 150ml in the main and 50ml on the cshaft and I was good.
@SkillinTime10 ай бұрын
I've been getting feedback on this oil change u can remove the two 10mm bolts from the bottom center of the case to change the oil
@jimmypalumbo9932 Жыл бұрын
I need to order some can’t find them or can you tell me the size of them
@SkillinTime Жыл бұрын
www.ebay.com/itm/354303652866
@rafaelmercado57713 ай бұрын
So you can remove the 2 10mm bolts and not have to remove the Alan bolts ?
@SkillinTime3 ай бұрын
I've heard both ways after I made this video...the way I did it worked but people were saying do the Alan bolts
@martinking2825 Жыл бұрын
Would it be the same as a 2006 ??? Sorry a little new to small engines
@martinking2825 Жыл бұрын
/a little hight too
@camillejones9185 Жыл бұрын
Do you know where to get that oil dispenser? That will be a game changer
This one is identical to mine but if I remember right I bought mine at Walmart or a parts store like orielys a long time ago
@witherowpowersports11 ай бұрын
Don't touch the allen plugs. Only use the 10mm bolts with crush washers.
@SkillinTime11 ай бұрын
U can do it either way...bolts or Allen heads I did the Allen head way....
@witherowpowersports11 ай бұрын
@@SkillinTime no those are for machining. Check the manual it tells you to use the bolts. Says nothing about pulling plugs that's should not be touched.
@jeisona547011 ай бұрын
DO NOT DO THIS.....THIS IS NOT HOW TO CHANGE YOUR OIL THOSE ARE NOT DRAIN PLUGS
@SkillinTime11 ай бұрын
? Ok
@SkillinTime11 ай бұрын
U can take out the ten mil bolts or u can take out the Allen head bolts if they aren't drain plugs then why did oil drain out when they were pulled?