This guy is absolutely correct. That jet seated in the plastic thing on top of the carb is TINY. It will take a really small piece of wire to run through it. Probably good to check the other jets if the bowl is really gummed up.
@timbernicolehermani954112 күн бұрын
OK question I cannot get that bolt out the threaded stem that holds the carburetor in place is there another way to do it because my vice grips are just kind of stripping the coding off of it
@Barrystimetoshare10 ай бұрын
If it has sat for a while or been bumped around a lot. Suck on one of the lines after the T coming of of the bottom of the Carb to reset the float. It will crank right up. I have the Same model and have had to do it twice. If that doesn’t work take the muffler/arrester off and make sure it isn’t clogged along with the air filter. use non ethenol gas only. All a lot easier than take everything apart for no reason.
@timbernicolehermani954112 күн бұрын
I cannot seem to get the threaded stem that holds the carburetor on. Off my vice grips doesn’t grab tight enough. Is there another way to get this out?
@timbernicolehermani954112 күн бұрын
5:47
@fishtacoguy5 ай бұрын
This Westinghouse is just a horrible design by whomever. I had problems with this model from day #1, leaking fuel everywhere during a power outage. I'm pulling the carb, lines and filter, cleaning and replacing and I'm then selling it. I replaced it with a Generac, no issues.