How to clean out your PW80 carb!

[@broncofa]

Nice. I usually take off the carb and it's a pain in the rear to get in/out - detach/reattach the throttle cable/choke. Just loosening the carb and rotating it is genius, thanks.

[@ih302]

Yep, that was ingenious, I did it with my son's p-dub and it worked great, much better than pulling the carb.

[@aidentully70]

What should I use to clean it if I don’t have carburetor clean spray

[@josephkim5999]

Would this be good to do to my sons bike its been sitting for about 4 yrs idk if it will even turn over i bought a carburetor rebuild kit hope it works thanks for the video

[@BennyObscene]

For that situation you might be best off completely removing the carb and giving it a proper rebuild

[@helloo7984]

@@BennyObscene thx for the help

[@LouieLouieUSMC]

Hey thanks for the vid. Have a question for u. I just bought one for my son. Its used. Already did what u showed on here. I dont know much about those pw80s. I have seen vids to put oil in the bike where it says yamaha just above the foot brake. Then i have seen some guys put tranny oil in there. Which is it? And also what kind of oil goes under the seat? Thanks a bunch.

[@BennyObscene]

two-strokes like the PW80 run off a mixture of gas and oil. unlike your weed wacker though, the PW80 has a separate oil pump which allows you to put straight gasoline in the fuel tank. so you put two-stroke oil under the seat, and the pump will automatically mix it into the engine. some people don't trust the pump, so they delete it and put a gas/oil mixture into the fuel tank.

[@ingleberthumperdink9455]

Back away from the bike

[@bindig1]

You really should wear safety glasses when using that carb spray

[@mark07021988]

Nice video

[@ih302]

You can also just turn the gas off and rut the carb dry... less mess that way.

[@ingleberthumperdink9455]

And you can also just shut the hell up and let him do it his way... less bullshit that way

[@ingleberthumperdink9455]

And you can also just shut the hell up and let him do it his way... less bullshit that way

[@ih302]

@@ingleberthumperdink9455 chill dude...

[@ih302]

@@ingleberthumperdink9455 Chillax dude, it was just a suggestion of another way to accomplish what was done in the video, for the benefit of those reading the comments.

[@jameswilliams1621]

If anybody ever sees this can you please tell me if you flip the switch up or flip it down on the right handle to start it. Thank you!

[@BennyObscene]

Flip up

[@jameswilliams1621]

Benny Obscene that’s what I thought. Because I’m rebuilding my buddies 80. So I did the carb yesterday and this video really helped!!! Thanks again!

[@Motolife92]

Where dose the lines from the cab go to ?

[@BennyObscene]

which lines?

[@seank1677]

what type of 2 cycle oil used for bike?

[@Farout397]

Yamalube 2S $8.99 USD here in Arizona. Which is a good price.