how to clear the pcp compressor when pressure can not up to 4500psi

This video is for the situation that all the screws is tighten and no leaking, but your pcp compressor's pressure can not up to 4500psi, even 3000psi. You can just try to clear the inner valve like it.
know more details, please at www.zypressure.com

[@radman731]

Hope all is well. It seems I can’t find much help troubleshooting my Yong heng. It had served me well for 2 years , but unfortunately it had failed me today. I have no idea where to start or what to replace. Both air chambers are holding pressure, but it just won’t go past 1500psi ( I usually fill my 100cu 4500 guppy tank , all the way to 4500. Never had a problem until today ) I do notice of a crank close the release valve (with a bit of force from a wrench) on the second chamber it will climb to 2000psi but if I hang tighten it will fall back to 1500psi and just float there running. I don’t know what to do. I can’t fill my tank anymore. Any help would be appreciated. I’m prepared to take apart, but I have no idea what to replace or look for , like I said.

[@laurencebaldivino8134]

i have compeessor not build up preasure

[@bashImpact]

good video, i have same issue and looking for this video, thanks for uploading..

[@Luminarialed]

Entendi!!!!! Que nem nariz, limpa com o dedo!!!

[@MA-hl6fi]

I have Yong Heng and it only goes 80 bars and there is no leak .. do you know what is the problem?

[@lifeisajourney5173]

the handy man nice video Aven

[@avenshang8543]

thank you

[@lifeisajourney5173]

your welcome i should have my pump very soon an will let you know how it goes ,i cant wait to shoot my .357 bulldog ,my first pcp rifle ,i been shooting my gamo swarm 10 shot .22 cal is fun an 30 cal break from hatsan single is a beast 50lbs to cock it,this one the .357 will go in the woods to shoot a few from 81 grains to 146 grains an up to 170 grains ,wich air guns or rifles do you like to shoot

[@avenshang8543]

i have no idea about shooting, because all the guns are forbidden in China, i have not even touch a real gun, never i have. so pity!!!

[@lifeisajourney5173]

yes i feel for you ,so only police an military can own guns ,that just may be what keep crime down there in china though ,i dont know ,hear most air rifles are not even regulated ,there are 2 states out of 52 that reglate them as a fire arm ,now fire arms to,in the right hand they are safe ,i am sure you see the thing that happen with gun hear ,it will take one foolish act with a high powered air rifle then they will regulate them ,but only for a few ,laws suck sometimes ,yes i feel pity for you Aven ,i went all my life without a fire arm ,couse of some trouble when i was young ,now working to restore my rights ,an the air rifle like said go to be careful with them

[@daledaled]

my pressure relief valve unloads at 1000psi. How do you adjust it? Thank you.

[@avenshang8543]

which model you own?

[@tidybananas3954]

I have the same problem but idk what model I own all I know is it has a 4500 psi maximum

[@sagargain4033]

Sir give me send 12volt pcp compreesar o ring set

[@avenshang8543]

please contact us by email, thanks

[@sagargain4033]

@@avenshang8543 sir email adress please

[@avenshang8543]

@@sagargain4033 [e-mail]

[@avenshang8543]

@@sagargain4033 [e-mail]

[@anne7606]

A typical butcher using shifters. Lol

[@ricardog5124]

conseguite una vida ya!!