How to Control DC Motors with L293D Motor Driver and Arduino

[@0nkar]

What if i wanted this to run without the usb plugged in? So it runs off the battery

[@EnjoyMechatronics]

● L298N Motor Driver: kzbin.info/www/bejne/p5KpfoanYr6Bock ● Arduino IDE: www.arduino.cc/en/software ♥bit.ly/3jvI8g6

[@forgewhelbon1131]

Thank you. Your channel is really helpful!! I made a mediapose controlled robotic arm with two joints (wrist n elbow) using ur open cv videos

[@Blusprunki]

HE'S BACK ! HE'S BACKKKKKKK !!!!!!!!!!!!!!

[@cornjulio4033]

Hi. Could I use this IC to switch a small 12v DC LED ? The LED is self-contained, I guess with an own driver. So I just need power on/off, not even PWM.

[@EnjoyMechatronics]

Yes 👍

[@paraskore3329]

thank you. Your block diagram helped a lot

[@EnjoyMechatronics]

You're welcome!

[@binayakbishnu]

3:52 does it matter which wire is positive? if yes, how to know which is which?

[@SWHS-JG]

Hello, I love your videos. One question. By any chance have you made a video the allows you to use a push button to turn the dc motor on and off? This would allow you to turn it on and off. I'm trying from your code but I'm having issues for some reason. If not, thank you anyways. Again, great videos.

[@halimmudia5451]

Thanks sir, are you have example code and simulation for speed control motor dc with PID using Arduino?

[@razvanefros411]

could we not power both VCCs from the power supply, provided that it outputs 5V? Also, would connecting all ground leads (4 from the L293D, 1 from Arduino and 1 from power supply) together on the ground bus of a breadboard work? Or do they need to be separate? thanks for the video, very helpful

[@mgglorioso]

Would this work with a servo motor? specifically deegoo-fpv MGM 996R DIGI Hi torque

[@Pavan4UB20EE03]

Sir which software did u used for executing the code,

[@sasithajayakody2574]

arduino IDE

[@SandeepJain-zo8bw]

i have tried all you said, still not working. can you help?

[@bobski1151]

My advice. Do not build this on a breadboard, the connections can be bad and will heat up the driver. Try solder it in place.

[@EnigmatusMedia]

Thanks sir!

[@DIGBIJOYDEBNATH-mx5ui]

Sir am doing my final project on RF CONTROLLER SOLAR PANEL BASED ROBOT VEHICLE...PLEASE GUIDE