How to Easily Install/Stab An Engine at Home in 15 Minutes Like A Pro

[@robertwest3093]

I’m really enjoying your channel since I found it. It looks like it is growing pretty well! I also like it that you actually take the time to read and respond to the comments.

[@unclebucksgarage7695]

Thank you so much! I appreciate it very much

[@tryingtoliveforever7490]

Awesome

[@unclebucksgarage7695]

THANKS

[@J5swagg]

Just discovered your page. Doing a complete rebuild on a 72 c10. Can’t thank ya enough for all these tips you’re putting out!

[@unclebucksgarage7695]

I APPRECIATE THAT VERY MUCH!!

[@usmclee65]

Great job Uncle Buck! Those were great engine hoist back when they made them!

[@unclebucksgarage7695]

You got that right!

[@BudFranks-fu9ye]

Very nice 👍💯

[@unclebucksgarage7695]

Thanks for the visit

[@tims72demon]

I left the tranny with the torque coverter in the truck. Pulled the engine out by itself. I got one of those air cylinders. 👍 So I have to drop the new engine back in by myself. Up & over the front end with the hood on. Up in the air about 5’. I did take off the front hinges so the hood would stand up 90° 👍Cleaning up old wires and painting while the engine is out. Good video Thx 👍👍👍

[@unclebucksgarage7695]

THANKS FOR WATCHING GOOD LUCK ON THE BUILD

[@gregHames-u6n]

Good job man

[@unclebucksgarage7695]

THANKS FOR WATCHING!

[@robertwest3093]

Also I was wondering which intake manifold you are using? I don’t think the engine assembly video got that far. I look forward to your response.

[@unclebucksgarage7695]

the Edelbrock Torker that I found and cleaned up is going on that motor

[@antj211]

Sure is nice to not have a whole front end in the way makes life easier for sure

[@unclebucksgarage7695]

Thanks for watching