How to extend/increase distance between arduino and relay/sensor.

Рет қаралды 3,274

Күн бұрын

Пікірлер: 19

@siva_b_1999 3 жыл бұрын

Nice video...by the way, I have a doubt....extending the wire leads to loss of voltage right? will it affect sensor reading? how will you rectify it?

@clickthatmoment3062 3 жыл бұрын

Yes extending wire will lead to loss of voltage try using external power for you sensor if possible.

@AkshayPowar-ws2zm Жыл бұрын

@@clickthatmoment3062 Will voltage loss be more than 20% for length of 1 meter??

@clickthatmoment3062 Жыл бұрын

@@AkshayPowar-ws2zm you can easily use 1 meter of wire without any voltage loss here i have used 22 meter of wire without any problem.

@1986ah 2 ай бұрын

Did you get noise in your input ? Because in my case, i have a lot of disturbance especially when i power 220v. How can i avoid that ?

@clickthatmoment3062 2 ай бұрын

In my case i didn’t get any noise i have use 15 meter long wire you can use high quality cat6 wire which is outdoor rated. Or you can add a capacitor on power line of relay to filter out noise. Use external power supply for relay. And another separate supply for arduino. Check your arduino if it is working properly or try replacing your arduino.

@hermes0000 Ай бұрын

Hello friend, cordial greetings from Mexico. I need to develop a project with an Arduino nano and an IR motion detection module that must be installed 15 or 20 meters away. Do you think it will work or what do you recommend I do to achieve it?

@clickthatmoment3062 Ай бұрын

Hello, thanx for watching. Yes it will work but IR motion sensor sometimes gives false detection if doesn’t affect your project than go for it. If it doesn’t work let me know then we will see another solution for it.

@hibusari131 Жыл бұрын

How you will provide the external power to seperate sensors ?

@clickthatmoment3062 Жыл бұрын

by keeping ground same you can connect power directly to the sensor by attaching positive and negative wire to it but note that do not connect sensor positive to the arduino when you are using external power and this method does not work for all sensors.

@kishor_VU2MZT 6 ай бұрын

MY QMC588L ARDUNIO AND 16X2 LCD WORKS PWEFECT WITH 10 CM JUMPER WIRE BUT ONCE CONECTTED QMC588L WITH 15 MM POLYCAN 1AQ MM CABLE SENSONR LCD NOT PRINTING READINGS HOW TO FIX IT ?

@clickthatmoment3062 5 ай бұрын

Some sensors or led won’t work with long wires due to voltage drop or fluctuations they are very sensitive to them. You can try to put a capacitor on power supply wires.