Great vedio sir.kindly provide the value of R54,R55,R56,R57 as i have the same multimeter but these resistances burnt and needs to replace.kindly help , waiting for your reply.
@hamzouz1229 Жыл бұрын
Thank you so much.. would you please show a clear photo of the knob selector pads because mine are scrambled
@tarashe_pc Жыл бұрын
yx-9205 selector
@edwardnavarro78339 ай бұрын
kzbin.info/www/bejne/oWOoXoF8p72al7M
@edwardnavarro78339 ай бұрын
kzbin.info/www/bejne/oWOoXoF8p72al7M
@ftavenezuela2 Жыл бұрын
I have the same one, the part to measure capacitors gives a wrong reading and it does not go to 0 when I turn it on, any solution
@tarashe_pc Жыл бұрын
This multimeter is not able to measure the capacity above 200uf and if the desired capacitor has a high capacity, then use a more powerful multimeter to measure it. for more contact me on telegram: @cyrusdgreat11
@Zedkhan5729 ай бұрын
Thank nice informative vedio sir .kly provide the value of R54,R55,R56, and R57. As I have same one but these resistances burnt and need replacement.waiting for your reply pse
@majidnaderii Жыл бұрын
سلام ممنون از آموزش های خوبتون. مولتی متر من ویکتور vc97 هست که یکباره یه مشکلی براش پیش اومد. قسمت بازر با تاخیر تقریبا 1 ثانیه بووق میزنه در صورتی که اینطوری نبود و سریع بوق میزد. اگه شما تجربه ای دارید لطفا راهنمایی کنید.ممنون
@tarashe_pc Жыл бұрын
درود بر شما بنده تجربه ی مستقیمی در این مورد نداشتم اما دو تا مورد رو حتما بررسی کنید بعد مولتی متر رو باز کنید اول اینکه از سلامت باتری مطمئن شوید بهترین باترین ها معمولا از نوع آلکالین هستند و دوم اینکه پراپ ها رو جدا کنید و در حالت بازر محل قرارگیری پراپ ها رو اتصال دهید و ببینید که آیا تاخیر دارد یا خیر؟
@pedropauloportella Жыл бұрын
too small video frame
@tarashe_pc Жыл бұрын
Yes you right , that was my mistake
@davidcromapix9083 Жыл бұрын
Bad video quality ,bad sound , and traslation is missing
@tarashe_pc Жыл бұрын
Thank you for sharing your opinion with me. In this video I made it accurate by turning the potentiometer that was built into the multimeter to measure the direct voltage And I set the power supply to 12, then I slowly turned the potentiometer inside the multimeter to reach the voltage of the power supply I hope I was able to get my point across.🙏