How To Fix Hook Timing And Replace Hook For Juki Lu-1510-7.

Рет қаралды 5,367

4 жыл бұрын

How to fix hook timing and replace hook for juki Lu-1510-7,dial to zero(0)the timing procedure also same the other machine like juki lu-1510-7and lu-1510N-7,turn on handwheel loosen needle bar screw,needle bar conection to adjust so that a clearance of a1.5 mm is provided between the top end of the needle,blade point,of the hook when needle bar raised by 2.3mm from the lowest position,the tighten the screw again,turn the handwheel make a needle bar ascend by 2.3mm from the lower position,and tighten back screw set,loosen the small gear screw ,when u install hook ,tighten screw first for groove hook shaft,loosen set screw for large hook gear and move right or left,adjusting blade point for the hook aligned with the centr of needle,Make a distance needle and hook 2or 2.3mm,and tighten screw.
👉I hope u enjoy this video.
👉If u like this video plz subscribe Technical Access and press the bell icon for more related video.
👉 • How To Setting Hook Ti... .

Пікірлер: 9

@jimbobxcityguy5338 Жыл бұрын

I can't believe it's so old and rusty looking. Mine is 17 yrs old and thou used it still is in great shape.

@sergie274 2 жыл бұрын

Nice video, just what I wanted to know. Keep sharing!

@DHARMENDRAKUMAR-or1sy Жыл бұрын

Very good

@ImranKhan-cw8nh 4 жыл бұрын

Nice

@mainstreampropaganda7518 6 ай бұрын

Wonderful video! Can you tell me how similar the procedures on a JUKI LU -1508 would be? Can I achieve results by following ❤ with some minor differences in mind? thank you for everything!