How To Fix TBS Crossfire Binding Issues (via Emergency Update Procedure)

In this video I am going to show you how to fix a common binding issue with your Team Blacksheep (TBS) Crossfire to your receivers via emergency update - applies when you see a rapid flashing green light. Emergency update may fix other issues with the receiver.
This applies and works for the following receivers with stored golden firmware version on v2.24 (mid 2018) with no additional hardware needed:
-Micro Receiver V1/V2
-Nano Rx
-Diversity Nano Rx
This does not apply to the full/standard diversity receiver as that has a micro USB port where it can be fixed with TBS Agent X.
The Procedure:
1. Put Crossfire Tx in bind mode
2. Hold the bind button and power up the receiver
3. Release the button after 2 seconds
(you will see green led flash rapidly)
4. Push and hold the bind button again
(the green led will flash in a slow double pattern)
5. Release the bind button when green led flashes rapidly
6. The receiver led will turn momentarily red and then you will be prompted on the Crossfire transmitter (or radio screen) to update receiver
7. Power cycle everything
8. Configure your receiver outputs (CRSF, SBUS, etc.)
9. Send it!!
Not mentioned in the video, please update the Tx to the latest firmware and or reflash it as some users have reported it helps with resolving binding issues.
For additional support and help, please contact TBS support or join their lounge group:
/ blacksheeplounge
Any questions or comments, please post them below.
Thanks for watching!

[@OfficialMatrixFPV]

For the dreaded solid green light, please try this:

[@garylainey4689]

I was struggling with this issue and this video help me, thanks so much

[@JasonParham83]

Spend two days trying to figure out why my receiver wouobind and update. This video for me up and running. Thanks 🙏

[@ShujaRashid]

your video saved me my transmitter, i would have smashed it to the wall. Bless you mate

[@AlbeeSoaring]

Thank you so much. I ran into this problem and this fixed it. Your my hero.

[@bobchannel8007]

I am so so grateful! You helped me so so much, can not even describe it! You are a true legend in my eyes :) The method 100% works!

[@masterpdj2623]

Thank you for keeping simple

[@flashfast2007]

Thank you man, my tbs is working :)

[@alialqadhi9444]

WOW ,,, man you have a very nice and cool stuff ,,, I like it.

[@MohamedBinkaram]

Thank you!

[@andresherrera3649]

Thanks it fixed it!

[@recepkarayanik]

Thank you 🏅

[@alexall]

Thanks, the way works

[@dhardjono]

yes that what happen flash green very helpful thanks

[@fyourface9221]

Ty sir

[@lastepisode8118]

Greetings

[@lucbisschops]

Nice video, I have done all you said, only mine is not going in to a rapid flash again for the second time, but turns solid green after the double green flash :-(

[@NoviceQuads]

Does this work if the receiver light is blinking slow

[@Markq666]

I get my drone to bind and update but once I swap battery the receiver gets unbind and starts flashing fast. You think this would fix it 🤔

[@monacocross4241]

to 2min 08sek all good done same , but after 2min 08sek remote tango 2 not show any update , help ?