How to get an intake manifold to fit perfectly.

In this two part series we show you the importance of proper intake fitment and how we do it. We make sure everything is going to fit how it should before it leaves our shop.
Check out our website for more product info and our facebook for updates and be sure to like and subscribe!
www.castheads....
/ brzezinski.racing

[@louknapp4257]

Nice video - as much as I like them, I find edelbrock intakes have to be milled more commonly than other intakes. Also - if you live in a smaller market, it is HARD to find a machine shop that will mill an intake. Maybe it is just my area...

[@limitsedgemachineworks1433]

I have all of the stuff to mill down intake and exhaust manifolds at my shop in the Tulsa area. It is just very hard to keep a manual job shop going these days, if your hunting money you are hunting jobs that you can run over and over not a different job with different requirements that you are only going to run once. I am glad to provide the service but it is a labor of love still at this point.

[@ThePaulv12]

After modding the bolt holes like this I'd like to put the distributor in before nipping the bolts prior to torquing I feel.

[@67cudaksa34]

i know this an older video. I am building a stock eliminator 305 and needed to see how to align the ports to the head.

[@Supanova70]

What gasket do i use for my edelbrock performer on iron eagle heads? there is a gap at the runners. Seems heads were milled before i got them. sbc 1970

[@Supanova70]

So we have been struggling with a sbc 355 with dart heads that have been milled to the max. we use .120 1266 intake gaskets. Blowing smoke out the #8 cylinder only on a fresh build. Noticed china rail to close like .0005. had it cut .060 same problem. i added oil die and the only runner that glowed was #8. Any thing i need to check? we are lost here. Maybe another .060? Did a leak check on cylinder checked valve guides and seal. Also rocker stud. all was new and sealed.

[@edwardwood3622]

If my block is decked, how much will it affect the fitment?

[@markday2198]

Do you sell aluminium intakes for 906 votecs . ( specifically with TBi )

[@keenanfrith5790]

Throw the tbi away