How to Install an LED Light Bar on a UTV | Kawasaki Mule | Partzilla.com

[@vpr3i]

John, I just wanted to say THANK YOU for your help. I ride 2010 cbr600rr and you and your cbr600rr maintenance series are two of the reasons why I don't want to change bike. By far the best instructor on KZbin. Thank you!

[@chrisowens3365]

Keep up the good work! Love your videos.

[@USCAVHOOAH]

If wiring up multiple lights to run from one switch, do you have to run them through a relay if using this fuse box, or just write them in parallel using the same method as in this video?

[@loboway]

John if at all possible could you do an install like this but with one of the 2017 or newer Polaris sportsman 850 or 1000. Thanks

[@34dawgsgo]

Would like to mount one on the top rear of the cab to serve dual purpose as rear bed cargo light and backup light. Any suggestions? Thank you.

[@PartzillaParts]

Same basic process, just a lot more wire.

[@34dawgsgo]

@@PartzillaParts thanks.

[@heehawanderson7810]

Try using a razor knife to cut the knockouts for your switches it's super fast and a whole lot cleaner and they cut like butter

[@LTVoyager]

Looks like a near installation, but the Kawasaki connectors did not look to be sealed auto quality connectors like Weatherpack and similar. Given that, I would pack them full of dielectric grease and I would apply shrink tubing over the splice.

[@tylerstone8219]

Just bought a 2015 Mule Pro FXT. Great condition. Checking everything out. Found that the two 12 volt accessory sockets in the front panel do not work. I think I found the fuse, ACC F. Fuse not blown. Any ideas why it would not have power. Reading 0.07 Volts???

[@PartzillaParts]

Bad connection, corrosion?

[@JonJon501]

the acc wires in front under the hood are for the horn and arent meant to be a constant 12v supply

[@hayneshuntingcom]

John is great. Question: hurt anything to put on 30" tires on my 2016 Mule 610 XC 4x4?

[@PartzillaParts]

I don't recall ever seeing one with 30" tires. Not sure, I would verify the clearance in the front first.

[@Eric-pi9ek]

I installed a light bar on my Kawasaki Teryx4 LE a week ago. For some reason the unit would not start. Dead battery... I put the wire harness that came with it on the unit.. not sure what’s going on? Should I buy a wire harness from the factory? Or?

[@PartzillaParts]

Either you have a short and battery drain or blew a fuse?

[@texteb]

What about a video on an sx?

[@stevestewart9605]

What $

[@ViralAwakening]

You don't have to have that fuse box harness

[@countryflyer4536]

wanted to know how much for the kits, you have to create an acount, then add to cart, then check in check out...what a scam !!!!!!!!