Filming in landscape would be much nicer. A lot of people who use their phones to film don't know you can hold it horizontally and it'll film in landscape. Gives a much better view, a wider view also. I'll be putting front liners on my F350 soon as it arrives, so thanks for the video
@OESbike1 Жыл бұрын
Thank you for posting this. Very helpful. Essentially same instructions and setup for a 2023 f350. Did you have any residual gap along the front edge of the wheel well liner? No matter how much I repositioned/ pulled or reshaped the plastic well liner the front part (edge facing the bumper on both driver and passenger side) had maybe a half cm gap.
@thuhmann1 Жыл бұрын
That's interesting. I didn't have any gap. Mine fit perfectly.
@jabster295710 ай бұрын
I have the same issue, did you end up getting it to fit properly or said screw it and left it with the gap?
@jsalrin12 жыл бұрын
Troy, very helpful, thank you. Question, did you have to remove the factory carpet liners or did these install over the top?
@thuhmann12 жыл бұрын
I left the factory carpet ones. They hold all the engine bay crap that’s attached to the fender wells.
@brianr18992 жыл бұрын
Do the plastic liners cover any more of the open engine bay area holes Ford decided to leave open with the carpeted liners?
@kennnva5512 жыл бұрын
Troy - Go to your 0:09 mark and you'll see that the instructions do indeed say to loosen the two screw/bolts at the fenderwell's rear face (2 black arrows). BTW, thanks for the video guidance! EDIT TO ADD: Installed mine today and found something not included in the instructions. Yes, my 2022 had the 10mm bolt heads at the forward ends (not Torx) as stated in the instructions, but I came upon 7mm bolt heads at the aft end ... not 5.5mm. This might be related to having the factory mud flaps installed on my King Ranch F250.
@ChicagoBears360_CoachT2 жыл бұрын
Do mind me asking how much they cost from Ford? I can't seem to find any for the front any beside Ford dealer
@thuhmann12 жыл бұрын
I used my Ford Pass points to buy them. I don’t know what the cost was or how many points it actually took. If I was to guess I think they were less than $150
@rickketchumn44583 жыл бұрын
Thanks for the how to it help a lot but did you leave the carpet ones in or take the out thanks
@thuhmann13 жыл бұрын
I left the carpet ones in. The plastic installed right over the carpet easily.
@tominaklan9702 Жыл бұрын
Anyone know if the fit the F250 I can’t seem to find any online
@thuhmann1 Жыл бұрын
Yes. it will fit an F250.
@DennisJoy4833 жыл бұрын
Thanks for the instructional video. The instructions Ford included with the wheel well liner kit were less than helpful. Watched your video and completed the install in 20 minutes.
@thuhmann13 жыл бұрын
Most welcome. Glad I could help out.
@DJCocoaPuffz3 жыл бұрын
Why would you record this vertically? You (and we) lose 2/3 of viewing area. This is asinine.
@patriotone7552 жыл бұрын
A Brother is doing what he can to help everyone out. Why be so critical. Maybe post your own install video or keep scrolling. 😉
@nickmalatesta4007 Жыл бұрын
@@patriotone755 Seriously! It was a simple install video not an engine repair 😂 If you can’t get the information from this vertical video you probably shouldn’t work on your own truck