Awesome video ❤ I heard you meet chadde and Tammy did you also get to meet Ryuk 🐺
@Freewarden Жыл бұрын
Yes, it was a pleasure to meet them and hang out for a short while, the girls gave Tammy a tour of the animals. Great folks!
@GinaBeana_Tootsie Жыл бұрын
@@Freewarden so good to hear ♥️
@mattdewhirst4075 Жыл бұрын
Timely video for me as I explore this option for my place. What size post do you recommend for the timeless system.
@Freewarden Жыл бұрын
That depends on what you’re running in it? What animal are you keeping in?
@mattdewhirst4075 Жыл бұрын
@@Freewarden Pigs and sheep, no cattle.
@Freewarden Жыл бұрын
What sort of terrain? Hilly or flat? Do you have a lot of predator pressure from coyotes or anything else?
@mattdewhirst4075 Жыл бұрын
@@Freewarden Hilly and no significant predator issues, this far
@Freewarden Жыл бұрын
Then I have two suggestions for you. For your perimeter fence I’d encourage you to run a five wire high tensile fence with wires spaced (from ground up) 6, 12, 18, 30, and 42 inches. To accomplish this use a 1.5 to 1.75 diameter by 5 foot (or taller) t-posts. 1.5 will be most economical and still get the job done. They are going to be a little less costly than 1.75 diameter posts (check your local dealer’s pricing). The 1.75 diameter posts are a littler beefier, are easier to drive into the ground, and look nicer in my opinion. I have farmers who run both without a problem even 1.5 for cattle. That fence configuration will be good for pigs, sheep, and just about anything you could run up to and including cattle. For any inside fences you can run a 3-4 wire fence. I’d suggest running your wire at 9, 21, 33 inches, or 6, 15, 27, 39. If you think you may ever want to run a taller fence go ahead and get the 1.75”x6’ posts and never look back. You’ll have room to add a wire as high as 5 1/2’ and they look great! If you install anything 6’+ tall, don’t use 1.5” diameter posts. It feels like trying to pound licorice into the ground. If you have very hard or rocky soil, I definitely recommend pre-drilling a pilot hole using a right-angle drill that is 1/2” smaller than the post you’re installing. You can buy 18” auger bits from timeless, or pick them up from your local hardware store. Harbor Freight has a really cheap set you can buy for next to nothing. Lastly, make sure you drive the post to the printed mark at 18”. No more, no less. If you drive them further in it creates a weak point where they can snap off at the first pre-drilled hole. If you don’t drive them in far enough they can be weak and come loose. Any further questions, let me know.
@shirleymontour97732 ай бұрын
Gripple contactor tool link only links to gripples.
@Freewarden2 ай бұрын
Yes
@shirleymontour97732 ай бұрын
What are the twisters called after tentioning the fence and where to buy them?