How to install SKR 3 EZ in minutes!

[@dressyspider]

Thank you for the video. I will be installing the SKR 3 EZ in and Ender-3 Max Neo tomorrow.

[@walterkuhn2080]

Can you comment how to configure microstepping for the EZ2209 on the SKR 3 EZ in Marlin? It seems to default to 16 but the driver is supposed to be able to do up to 256 microsteps.

[@jamescannon2587]

I need some help here. With the wiring. I am upgrading my B1 from a SKR 1.4 Turbo mainboard to an SKR3 EZ. The problem is that I have no idea where the wires labeled F ANO, DCIN, NEO, an unmarked thin white 2 pin cable (yellow pins), and what appears to be 2 fan cables are supposed to go on the SKR 3 board... And there is very little online help :(

[@fisheye3d1727]

I got two sets of there ez drivers, first set 2 of them would overheat, second set 1 didn't work.. went back to reliable reg tmc drivers and have no issues

[@jeffs3dcorner]

Fair comment. Was this with marlin?

[@fisheye3d1727]

@@jeffs3dcorner No, Klipper

[@dcold]

Jeff, will this work for the Neptune 2 3d printer?

[@nielspaulin2647]

EXCELLENT.

[@noisy_boi_fpv_3920]

What not using klipper 😂

[@brandonmadden199]

Hilarious..

[@adtub]

sensorless homing is not working , customer support 000000, not worth money.

[@noisy_boi_fpv_3920]

Mine works in klipper just fine. Did you configure firmware and install jumpers

[@ryanh1986]

Good lord what a waste of time video. Informative I guess, but the title is "install SKR 3 EZ in minutes!"... Then the author proceeds to compare to other boards, skip installation to a completed scene, and then say "I have other videos about wiring, so you can look for that instead"... then moves to firmware. What? LOL you must be trolling.