How To Install The Graco® Turn2Me™ 3-in-1 Car Seat Rear-Facing using the Lower Anchor Attachment

Learn how to install the Graco® Turn2Me™ 3-in-1 Car Seat rear-facing using the lower anchors by following these easy steps. The Graco® Turn2Me™ rotates from rear-facing for a face-to-face connection with baby to get them in and out of the car with ease! Before learning how to install your car seat, you will need to know how to use the turn feature. The turn levers are located under each armrest, but you only need to use one to turn the seat. At the same time, squeeze the blue trigger and the grey lever and rotate the car seat. After rotating your infant car seat into the rear facing position, you will know your seat is secure in position after hearing a click. Next, take lower anchor attachments out of the storage position. After extending the lower anchor to its maximum strength, place the rear-facing car seat into one of its four positions.
Place the 3-in-1 car seat in the back seat of your vehicle. Slide it until the car seat touches the back of the vehicle seat. After making sure your level indicator is in rear facing, remove the infant body support and open the door by pressing the front of the seat. Open the SnugLock lock off with the grey lever. Here you route the anchor through the rear facing belt path. Attach your anchors to your lower vehicle anchor connectors for your vehicle. Once you have removed slack, close the Snuglock lock off. Finally check for tightness and adjust harness height accordingly for baby. You are now finished with car seat installation for the Graco Turn2Me 3-in-1 Car Seat.
Want to learn more about the Graco Turn2Me 3-in-1 Car Seat? Visit us: www.gracobaby....
Want to learn about Graco’s car seat safety standards? Visit us: www.gracobaby....
#carseatinstallation
#convertiblecarseat
#bestinfantcarseat
#gracocarseat