They didn’t show that you’re suppose to center the bell housing. The bell housing cannot be more than .005 thousands off center, or tremec will not warranty transmission.
@davidmalinowitz9033 Жыл бұрын
That was an amazing kit installation
@davecolquhoun93153 күн бұрын
And just a tip, wear gloves when you’re touching the surface of clutch, pressure plate and flywheel, or anything that you don’t want to contaminate
@jamessagar708016 күн бұрын
How did your stock speed ohmmeter cable length work out for you ? Did it reach after the Tkx was installed ?
@jagco25946 ай бұрын
What the bearing used co-laps info , pressure plates, disk, flywheel. I having a problem with the clutch fingers bear pressing into the fingers. I'm using a 153 teeth flywheel.
@guyyates3284 Жыл бұрын
Do they have a hydrolic clutch kit for the 67/72 chevy trucks .....I would like to see one ....
@car_ventures2 ай бұрын
Should be able to use 4th gen Camaro/Firebird hydraulic clutch. Throwout bearing, line and master cylinder should all work. Then just need a reservoir from anything.