How to interface your outboard to your graph, DIY NMEA 2000 network

learn how to create your own NMEA 2000 network to process your engines data on your electronics.. you can do this with any late model chartplotter and any outboard with a ECU.

[@fishin-impossible2992]

Good info Adam.

[@nauticalpridesportfishing8213]

Thanks man

[@georgiafisherman5050]

Picked you up from Palmetto Cats live at Catapalooza.

[@nauticalpridesportfishing8213]

Thank you so much we appreciate that

[@fabfishing7422]

Okay I don't know much about graphs but my take away from this video.. that motor sounds GOOOOOOOD!!! 💪💪😁

[@nauticalpridesportfishing8213]

🤣 purring like a kitten

[@fabfishing7422]

@@nauticalpridesportfishing8213😂

[@castineirachannel]

Good video is work in honda 2003 four stroke my gps is simrad

[@nauticalpridesportfishing8213]

Yes that should be capable

[@jbjohnson6228]

No, will note work pre 2006 motors

[@clearconcisecourteous9647]

🤔🤔🤔... Should have run cable FROM outboard TO---> dash... But otherwise good job. 👍🏾

[@beyondupnorth]

So pretty much any chart plotter that supports nmea 2000 and any fuel injected outboard and the correct outboard interface cable and you are good to go? Looking for a new graph for my 1700 tiller 50 Yam 4stroke efi and Helix 7 or 9 or poss Garmin chart plotter and have no good place for guages

[@nauticalpridesportfishing8213]

Yes that is correct, but still double check and make sure the unit has the capabilities to support that before you buy. Hummingbird should have a cluster just like lowrance

[@jerrytipler5]

Do it show hours

[@tommyrq180]

Engine hours is part of data available in NMEA 2000 from what I understand. You just need to know how to get your chart/display to show that value once you connect it to the engine.