How to LS Swap - Episode 9 - Exhaust Headers and Ignition Coils

Today we continue our ‪@SummitRacing‬ sponsored How to LS Swap series with part 9 Exhaust Headers and Ignition Coils. So in this episode I will show you exactly how to put headers on your LS swap project ours in a LM7 swapped into a 1955 Chevrolet Bel Air but the process is exactly the same for any car you would typically LS swap. If you have any questions leave them below and thank you for watching!
Headers I Used: www.summitracing.com/parts/su...
Header Search: www.summitracing.com/search/p...
Ignition Coils: www.summitracing.com/parts/su...
Instagram: / ryansgarage408
If you have a car question ask it completely free at www.2carpros.com/questions/new
#lsswaptheworld #lsswap #belair #diy
*Disclaimer: Please use all safety precautions

[@markmcintosh6968]

While you were doing this video, I was noticing the valve covers. Do you have any information on venting them? I see the vent on them were capped.

[@outsidethelines2162]

Only capped during install. He shows how to vent them later on in the series.

[@rodneyroberts5678]

What is your approx cost on this build? I’m pulling my 2007 gen 4 out to build and this is the numbers I’m looking for, build sheet? Thanks

[@2carpros]

For everything including the swap and all that? I have no idea. Here is the sheet for the engine though. www.summitracing.com/newsandevents/newproductreleases/2carpros-5-3l-gm-ls-engine-build-parts-combos-now-available-at-summit-racing Thanks for watching!

[@rodneyroberts5678]

@@2carpros mine is the Ly5 so I figure something’s are going to be different,