How to make a dehumidifier

[@emrem9465]

Yes you are right, density will decrease when fluids speeding up. And can evaporation again. But your application is hasnt circulation area. I want to put in a 100L isolated box for made small dehumidifier. Do you have suggests for me? Shoul I move hot heatsink to out of box ?

[@bakidilek]

my design is not perfectly sealed and there are small gaps all over it also diffusion is a powerful force that can do its job to balance the air humidity inside the box. a direct hole is not recomended. If you are going to use peltier as like me it wont change anything when you remove the heatsink out of box because the peltier will heat whatever you do. İf you can use a compressed gas cooler(refrigerator system) it will be far better than in this project. last one question, why do you write in English?

[@miroslavtezki3052]

Super 👍

[@JustaCuriousity]

Hi, interesting DIY. Did you measure humidity changes?

[@bakidilek]

No, I didn't measure the humidity. The area where I collected moisture was not a very humid place.

[@PADALACHANNEL]

When I use 12v 2amp adapter, adapter was blinking .....can you suggest an adapter which should not blink

[@bakidilek]

most likely your adapter is not 2 amps and blinking because its power rating can not reach the recommendations or it has some weird safety. try a different one

[@PADALACHANNEL]

@@bakidilek thank you

[@HuseyinBerkanAYDOGAN]

Çok güzel fikir dostum. Adaptörün ucunun dışı mı yoksa içi mi negatif acaba? Bilgim sıfır 😄

[@bakidilek]

@@HuseyinBerkanAYDOGAN bu bilgi adaptör üzerinde gösterilir. Adaptöre göre de değişir, kendin bulmalısın.

[@stevenhendler3064]

What kind of thermal paste did you use?

[@bakidilek]

Nothing that special. Just cheapest one.

[@estebanyanson]

Why do I want to remove the moisture that is inside the box? This does not remove the ambient humidity

[@bakidilek]

Bro it removes the humidity in the room and collect it in the box.

[@kotapatinageswararao6971]

Can I use peltier TECI 12703

[@bakidilek]

Yes.

[@manhngo4275]

interesting man! Thank you

[@benjaminlalrinzuala9543]

How many amperes do you recommend then?

[@bakidilek]

depends on the peltier that you will use. You can use 5A 12V.

[@benjaminlalrinzuala9543]

@@bakidilek ok, the one i got is 12v 92W maximum

[@bakidilek]

@@benjaminlalrinzuala9543 5A 12V means 60 watt, try not to exceed 75 watts.

[@benjaminlalrinzuala9543]

@@bakidilek thank you so much

[@bakidilek]

@@benjaminlalrinzuala9543 you are welcome

[@kotapatinageswararao6971]

How do you get the subscribers

[@bakidilek]

If they like what they watched then they subscribe your channel. That is it.

[@pKova55]

What a PITY! If you have demonstrated HOW it's done STEP-by-STEP, everybody would have been able to do it by themselves. Consider RE-DOING a similar Video, BUT this time SHOW ⇒ EVERY Step is made VISUALLY! And N-O-T ⇒ just the FINISHED product?