How to Make a Field Offset on any Duct

[@alexyenriquequevedoperez634]

Nice & Easy 🎉🎉 great Job ✌️

[@stevenstadterman9725]

THATS WHATS GREAT ABOUT DUCTMATE CONNECTIONS

[@BigBruPB]

Heck yeah man good Video Bro

[@winstonbuzon]

Thanks, man, appreciate it!

[@albertdesalvo7697]

Thank you for sharing bro cheers from Cali

[@Bill_CBR]

That's pretty cool. In looking at that, your offset was lets say, in the X direction. It seems that if you had a compound offset like X and Y (right and back), you could do it twice on both ends. Once for over to the right and one for moving back (or whatever directions you needed to go, front/back, left/right). Nice demonstration.

[@محمداکبری-ز5د]

Good job

[@winstonbuzon]

Appreciate it!

[@bryanflores9369]

So you did a 2 inch lip marked it then marked the 1.08 inch to zero right?then cut the 2 inch lip and notched the 1.08 to over lap it

[@JuanPerez-o4k8m]

Professional

[@mastermoviecritic8297]

Nice bro! Now do you have any good ideas on how to peel that awful blue wrap? Now using a wire wheel but it takes the zinc coating off😖

[@winstonbuzon]

You got that right about that annoying blue wrap!@@mastermoviecritic8297 🤣🤣🤣 I tell my junior guys not to drag the dang duct on the ground bc it makes taking the blue off a pain in the ass! But a trade secret: Ball up some old duct gasket and rub it on the messed up blue wrap like a clay bar

[@mastermoviecritic8297]

@winstonbuzon Good advice. I like that. But I can't help but think there is a better way still. I tried a scraper, a razor, a clip, a heat gun, lime juice, fairy dust, Thanos freakin infinty gauntlet 🤣.. if I figure something out, I'll let you know

[@mastermoviecritic8297]

Just kidding about the lime juice 😂

[@winstonbuzon]

@mastermoviecritic8297 I'd rather use that on my tacos from the lonchera 😂😂😂

[@chevy9256]

I’m in the sheetmetal workers local 104 San Francisco

[@Craptainfalcon100]

What about ducts that arent square? My journeyman was trying to teach me that sometimes you put the switch the length and width depending on which direction youre going. I got pulled away to do something else in the middle of the lesson

[@winstonbuzon]

@@Craptainfalcon100 then it all depends on which directions your offsets are going and how much space you have to spare. If I get another chance, I will demonstrate on rectangular shapes for example

[@winstonbuzon]

kzbin.info/www/bejne/hou3iJ13ltCrm80si=hpRU-YCLh0RVilEn

[@RaulFernandez-s7u]

Haz más offset,45,90 trnasicion