How to make a powerful 3D printed brushless motor 500w

How to make a powerful 3D printed brushless motor 500w | DIY project 2024

Рет қаралды 23,229

American Tech

Күн бұрын

Пікірлер: 19

@ShawnRitch 10 ай бұрын

Wonderful job. Very meticulous work :)

@ThatGuy-bx4yi 2 ай бұрын

🎉❤❤ u r very brave boy. Such strong hands to withsstand that BEAST of. Motor

@AmruMagdy 12 күн бұрын

Thanks ❤

@Jim_One-wl4ke 5 ай бұрын

Good job. May I know Why 8 magnets 12 coils? Thanks for sharing ❤

@vanquangluong4054 7 күн бұрын

Can I use it as an alternative to an e-bike?

@gkdresden 3 ай бұрын

Nice, I am curious about some measurement results relating to output power vs input power. You could use the good old Prony brake with two calibrated force measurement cells for torque measurements. When you use disk magnets you can also use circular coils. They are considerably easier to make. Furthermore you can use Iron (or low carbon steel) rings at the opposite side of the rotor disks to make a yoke to bridge the magnets in order to increase the magnetic flus in the air gaps. In this way you can also get lower magnetic flux pertubations around the motor.

@andySpec445 Ай бұрын

What is the COP?

@REVY10 10 ай бұрын

👍🏼👍🏽👍🏿👏👏👏

@RahulYadav-b3t 4 ай бұрын

can you please help me in stator winding and connection or how can i connect to you?

@fuahhuah 10 ай бұрын

i m first

@ЮрийЛопатин-г6л 10 ай бұрын

Я второй.

@ccc822007 10 күн бұрын

What type of motor is that? Single phase, 3-phase, or Synchronous? I already know Just seeing if anyone else knows.

@rohit07898 6 күн бұрын

3 phase

@darrylnelson1995 Күн бұрын

I watch similar videos and always wonder the same thing... Everyone makes winders for filament that lay it down precisely on the reel, but none of these motor makers makes a winder to neatly of turns for their motors. What gives? You are obviously creative enough to make a motor, and you know it needs wound precisely, so let's see you complete the circle...