How to make arduino long range transmitter & receiver upto 15 channels

Hello everyone in this video I'll show how to make a 6 channel low cost professional radio control for RC aircraft models, UAV, drone, cars and boats, robots 500+ meter range under 10$. CODE Link is in below
This cheap remotecontrol supports PPM, PWM which are commonly used in projects.
Channels can be increase upto 15 channels.In the Tx and Rx code remove "//" before the channels 7,8,9,10,11,12,13,14 and 15 to increase channels.
Project Details ,Codes and Circuits - elecobot.blogs...
Materials:
1x Arduino UNO for TX
1x Ardino NANO for RX
1x NRF24L01 PA+LNA module for TX
1x NRF24 module for RX
2x Joystick Module
1x Togle switch
1x Potentiometer
2x AMS1117 3.3 volt regulator for NRF module.
2x 100uf 16 volt capacitor for NRF modules.
2xRed indicator LED for RX and TX
1x ON/OFF switch for TX
Other Materials:
Sg90 servo
A2212 BLDC motor
SimonK 30 Amp ESC
3S LI-ION battery
🤗If you want to support my channel🤗 By Me a ☕Chai☕ -- buymeacoffee.c...
Instructables -www.instructab...
Follow me on -
WhatsApp Channel Link - whatsapp.com/c...
Instagram - / _elecobot_
Facebook - / 100077394460408
Arduino helicopter electronics discussion video link - • Scratch built Rc Helic...
Diy BLDC motor for rc helicopter video link - • Diy Drone motor. How t...
arduino robot bird / ornithopter video link - • Arduino BIRD 100% fly ...
So, thanks for watching, don't forget to like, share and subscribe my channel.
Thanks to NCS fro background Music.
#arduino #arduinoproject #diy #howtomake #homemade #rchobby #rchelicopter

[@TYFOONGAMER]

Thanks for sharing your knowledge with us.keep it up.😊

[@sushansapaliga3183]

Nice soldering skills!

[@SakshamMahajanB]

Bro should make a LED tv now 😂 , maybe it will be easy for him

[@subhajithalder3358]

😂😂

[@elecobot]

😅😅😅

[@OffShore-u1h]

Hlo bro apne 3:10 time per reciver dikhaya hai vo reciver banakar dekhayo or plz usta circuit daigram dedo with ic not Arduino plzzzzz

[@elecobot]

Circuit diagram is available on blog link in description. I used atmega328 pb microcontroller(IC).

[@OffShore-u1h]

Bro can i use atmega6a because its low cost

[@OffShore-u1h]

​@@elecobotsorry atmega8a

[@OffShore-u1h]

Bro ap mera comment deyan se read karo ma kon sa daigram mang raha hu plzzz daigram with atmeg ic not Arduino nano plzzzzzz

[@elecobot]

@@OffShore-u1h compare the pins functions and supported code of atmega328 with your microcontroller. If both has similar matches you can use that. You can order from ROBU.IN products are quite cheap and works good. I also use Arduino nano price 180 Rs. Atmega328 price 242 rs. Arduino nano 200rs.