How to make Smart Garden Project Using NODEMCU | KME smart

[@martinloeffler2119]

i like your content improvement idea to not flood the plant with too much water ;-) when moisture is low start pump, but stop after x seconds than wait/delay e.g. for 1 min than measure again to see if more water is needed or not to reach the target moisture

[@EDISON_SCIENCE_CORNER]

Yes that's possible brother. I just demonstrated like this

[@wizardlina]

hello i need your help i want to made this but i have not got all this so i want to ask how i can do this with arduino water pump moisture sensor and l298 motor driver if you can i need this info aboout 2 days untill 8 july can you give me answer

[@EDISON_SCIENCE_CORNER]

Check my other videos there is tutorial

[@drelectronics13]

Nice tutorial 👏

[@EDISON_SCIENCE_CORNER]

👍

[@thomsdixon3246]

Which type of node mcu is used

[@Rudra_Singh_Bhardwaj]

I think it's esp8266

[@EDISON_SCIENCE_CORNER]

You can use any type

[@EDISON_SCIENCE_CORNER]

You can use any of the nodemcu

[@thomsdixon3246]

@@EDISON_SCIENCE_CORNER thank you ❤️

[@midhunmathew1268]

👏💯💯

[@EDISON_SCIENCE_CORNER]

🌞🌞

[@adihiwrale7604]

this did not need code

[@EDISON_SCIENCE_CORNER]

Yes