How to make trigger stops on any controller

Trigger stops for Gamesir Kaleid, but works on any controller.

[@toxickid107]

LOL, this is so simple that it's even genius, thanks for the idea, bro

[@acfire9227]

You're welcome, glad it helped!

[@Swalla]

How are they holding up

[@acfire9227]

Done it on multiple controllers, only had one fall off on my G7se. It only takes 5 minutes to fix. If you really wanted to make it stay put forever you could do two on each side incase one falls off.

[@HoPPa8SkiT]

Funny video 😁 Boom Boom Boom 😆 So, what was the measurement then between the plastic piece & the edge?

[@acfire9227]

Haha, thanks Hessmo! The measurement is the minimum distance for it to register. We want the pull to be as short as possible for obvious reasons so that's why we measure beforehand. You can measure in game or in your controller software depending on the controller you're using. Once again you're measuring where the trigger registers so you can make the range of motion as short as possible. It's super easy when you actually do it

[@HoPPa8SkiT]

​@@acfire9227I simply have to try that. I thought more because you tried a couple of times so you might have an approximate measurement. I have both G7 SE and 2 of the HE. How will the control be afterwards in the plastic? Does it wear down a lot or did you choose a softer piece of plastic for this?

[@acfire9227]

@@HoPPa8SkiT I've been super happy with the results, and no the plastic doesn't wear down.

[@AnjillouBoubou]

What are the material that you used for the game the sir g7 se because I have it and I want to try it?

[@acfire9227]

Plastic + Glue

[@AnjillouBoubou]

Where can i find that type of plastic please ​@@acfire9227 ?