How To Make Your Snowblower Throw Further W/DIY Impeller Seal Kit !

Installation procedures to install impeller kit on your snowblower so you can throw snow farther and cut down on clogging issues.
Links for Part 1 and Servicing the augers will be shown at end of this video and/or check playlists on channel.
Thank you for liking and subscribing to this channel for How To tips on saving money with Do It Yourself maintenance and repairs for your snowblower.
Please ask questions, comments, suggestions in comments below the video and I will get to them.
Thank You.

[@HondaSnowblowerEnthusiasts311]

This is Part 2. I will link part 1 at end of video or check our playlists to watch it. This is a great off season project that only takes a couple hours or less so you can throw snow farther and cut down on clogging. Please SUBSCRIBE to stay notified on more upgrades and saving money on do it yourself maintenance and repairs on your snowblower.

[@robertdavis6708]

Buy you a bottle of Tap Magic . It gives the drill bit bite into the metal. Saw it in use in a machine shop and made a believer out of me. Best money I've spent to assist my drill press.

[@HondaSnowblowerEnthusiasts311]

thanks. i use some cutting oil that works for me but I'll try this Tap Magic, I drill a lot of holes thru impeller fans for impeller kits and wear out the bits even with cutting oil after about 70-100 holes .

[@HondaSnowblowerEnthusiasts311]

Have installed many of these. Did one on a Honda HS1132 snowblower and measured throwing distance at 118 feet !

[@user-bp2bc9yh8s]

Thanks for the tips! Install was a snap thanks to your advice. Can’t imagine trying to install these through the chute.

[@HondaSnowblowerEnthusiasts311]

I tried install thru chute and it took me longer that just removing the augers/impeller. Plus I was able to service the augers which I am going to do a video on in 2 days. step by step. thanks.

[@micheljalbert6106]

Thanks for the tips!

[@mikerathje1750]

Thanks!

[@HondaSnowblowerEnthusiasts311]

Thank You very much! Appreciate it. Anthony.

[@SVW1976]

I just did this on my Tru-Bilt 2665. Havent tested it yet. Need some snow! One day ill get a Honda with tracks. So nice 👍

[@HondaSnowblowerEnthusiasts311]

For me on my old Honda 80 it was a game changer.

[@martindesrosiers3880]

It would be nice not only to have a list of the tools you use but also where to get them..

[@HondaSnowblowerEnthusiasts311]

ok. thanks. i do have a small video on tools and lubricants you should have but i like your suggestion to expand on this. great idea.

[@danmorrissette4814]

Thank You!

[@HondaSnowblowerEnthusiasts311]

You're welcome!

[@jasonlong8625]

I’m getting a new HSS928 at the end of the month. Should I put an impeller kit on it?

[@HondaSnowblowerEnthusiasts311]

NO! Give it a try first. Plus I would be concerned about voiding warranty. If you have clogging issues ask your dealer first.

[@PainterD54]

I disagree,I install my paddle rubbers tight to the housing so they all rub the housing when it's running. Then all you need to do is let it run and let the rubber wear down so they all three rub at the same rate. Your blower will blow snow father and not plug up when the snow gets heavy.

[@HondaSnowblowerEnthusiasts311]

That's what I do basically. Thanks for watching.