Very clear video's mate 👍 Good job 👍🙏 I AM rebuilding a CB 650 rc05, Greetz Alexander
@jonathandosser8 жыл бұрын
Chris - another great video! And thanks for turning me into an ebay tool junky!
@trailerfitter28 жыл бұрын
Apparently the Td5 Discovery project vehicle sales have gone up too!
@stellarv56895 ай бұрын
Great video
@savindaunamboowe87686 жыл бұрын
Thank you for the video mate. Really helps alot. But the micrometer scratches my crankshaft journal when i move it to get the measurements. So scratches I can really feel it when i try to feel from my finger nail. Will those scratches later effect with any particles getting stuck between them? Please educate me with this type of situation because I cannot find a right answer for this. Thanks in advance
@trailerfitter26 жыл бұрын
You are being far too heavy handed with the micrometer. It should have a ratchet mechanism on the bottom of it to stop adding too much pressure. I am afraid if the crank is scratched it will need grinding out by an engine engineering workshop
@fionanokelly8 жыл бұрын
I saw you had three decimal, centesimal and milesimal digits on some of the measurement. If the micrometer is 0.01mm accuracy, how do you get that third digit..?
@trailerfitter28 жыл бұрын
There are micrometers that will go to another decimal place but they are very expensive. I had to compromise on these.
@trailerfitter28 жыл бұрын
When i see the marker is between 2 increments on the micrometer shown then i know it is .005mm.
@jswizzlestix25515 жыл бұрын
Veneer number
@Ken197008 жыл бұрын
Is there some advantage to a flat plane crank in an inline 4 cylinder?
@trailerfitter28 жыл бұрын
Now that is a question. Flat plane crank and cross plane cranks have their uses in engine applications but it is out of my knowledge area TBH. Plenty of stuff on the internet about the applications for either. I just accept what is used in an engine and make the best of what I have. Especially with old diesel engines.
@prasadgumaste15817 жыл бұрын
Land Rover Toolbox Videos
@Ken197007 жыл бұрын
It operates like a giant 2 cylinder. Maybe it's just a balance issue.
@mjallenuk8 жыл бұрын
I think she'll kill me if I suggest I need more tools...
@trailerfitter28 жыл бұрын
ah, but you know what you need for later. No need to rush out and get stuff yet.
@mjallenuk8 жыл бұрын
She'd quite happily beat me to death now or later...
@trailerfitter28 жыл бұрын
better do it then before you tie the knot with her.