How to press in a prop hub

How to press in a prop hub

[@paulvinyard]

It`s a Miracle you were able to get it done with that rig. Have you attempted the Yam. 61A bushing, without the front and Aft guides..?

[@itszo4168]

ru-glyde is what we used when i worked for a marine prop repair shop for 7+ years. Also we have the press and cones for the job. But you can't lick your fingers when using ru-glyde.

[@AudreyHaake-pi5vy]

Wanting to know if this worked. Afraid prop may slip under load. Will look forward to hearing back. Appreciate your help!

[@brittmarchbanks5527]

So far I haven't had any issues. I have probably covered around 100 miles with it.

[@brittmarchbanks5527]

I have been running the prop on my 200 yamaha. I haven't had any slipping issues

[@michaeldeangelis9877]

How did you make that funnel tool?

[@brittmarchbanks5527]

Go to A-1 race supplies and but a SS exhaulst reducer. Then cut it at the exact spot that matches the ID you need. Then I basically cut out a large washer out of SS sheet. Then welded that to the base. Thank for your question

[@johnherazo3376]

Como puedo conseguir esa herramienta para poder colocar el buje