How to program a Mhouse TX4 remote to gate control board

Mhouse Australia Distrubutor www.downee.com.au
Downee is a leading distrubutor of gate and fence fittings and automation products in Australia and New Zealand.
This procedure works on all Mhouse motors.
MODE 1
Button 1 - Open/Stop/Close
Button 2 - Pedestrian Mode
Button 3 - Open only
Button 4 - Close only
Did you know?
- That a Mhouse reciever can operate your garage door with a R2 reciever

[@deerose4220]

Thank you so much for this. ❤

[@andreaspapacosta3224]

Thank you for the short video. In two minutes I learned how to do it. The instructions were so confusing. Thanks again

[@georgesheds4843]

I have the exact same tx4. But I have a spring loaded limit switch to control when it stops in the open or closed position. The problem is that it is not recognising when the limit switch is activated and overuns. The limit switches are normally closed and working. I am not sure how to program the controller to read the limit switch. can you help?

[@91fleet]

I programmed a new remote which worked fine for several months. For some reason it has now stopped operating. I have tried the various delete & programme methods shown in the manual to no avail!! My original 2 are operating as normal. Any suggestion, ideas etc?? Thanks.

[@mockcensorship6185]

Hey, i've been experiencing problems with my own mhouse. It's the exact same as the one in the vid. The remote control itself does not work at all, however when i opened the box and clicked the switch it would open but wouldnt close. It's also not a battery issue as i recently just changed it. How would i go about trying to fix this issue? Please help, thanks!

[@RobBradshawG]

will any learning remote from ebay work for this? or does it need to be a specific one?

[@MrANCHOVIES2]

Easy!

[@harryphan1246]

Hi I have a problem with MHouse tx4 gate not automatic close how can I fix it? Any help for 4his? Many thanks

[@keev88]

How can I open the box to access to the electronic card?

[@maccasda]

the electician came and replaced the module and now my remote won't work , i tried this but it didn't work i wonder what i did wrong ?/???????

[@vikashvipin]

Ok