How to Program Compustar Remotes:Key start or Push to Start.

if you are programming remotes involving Push to start and or Key start vehicles.
Here is the process!
Key Start:
Cycle the key from OFF to ON 5x.
You have 10 seconds to do this.
Leave the key in the ON position when you reach the 5th time.
You will here the rely click and parking light flash.
If you have 2 remotes. Follow the process I mentioned in the Video.
Push Start
Ign On
Ign OFF
Ign On and leave it
You will have 10 seconds to do this
Press the brake 3x
Once you hear the click and park lights flash.
You are now on programming mode.
Follow the steps I mentioned in the video.
if you have any questions. feel free to leave a comment.
LIKE,SUBSCRIBE, and leave a THUMBS UP or DOWN:)

[@reyrodriguez2227]

Thanks for making this video life saver

[@FlipSideGarage]

You bet man. I have alot asking about how to reprogram them either when battery is replaced or just when it loses connection in general. So much easier showing it than just using words:)

[@LuisVazquez-cv2ku]

Thanks,yea it little hard in push start but works thanks again 😂

[@FlipSideGarage]

Good to hear that you got it going.

[@bignatesgaming8285]

Once the remote is programmed do you still have to keep the oem remote on you in order to drive?

[@FlipSideGarage]

Certain cars like ones with proximity sensor and push starts. Yes you have to still have the key inside.

[@drefz957]

If you have q9 then its that ok to reprogram the different key like t13?

[@FlipSideGarage]

They all program the same. Press lock button.