How To Rebuild A Toyota 4X4 Solid Front Axle (Part 4) Steering Knuckle & Spindle Rebuild

[@unitrecordcorporation9616]

My 1990 4runner was doing a buzzz noise and the spindle bushing was the problem ....3 auto shop couldn't find the problem they told ooh is the differential😣 And at the end I found the problem.. it was the SP and thank to this video I done my work and happy end ..thank you!!

[@mujahidali7632]

Berxxxx

[@mujahidali7632]

Cerxxxxx

[@chrisgrove5818]

Great video except You neglected to show the correct orientation of the spindle bushing. Does the "X"inside the bushing go up, down, front, or back??

[@taurusmonkey8780]

I bet Harbor Freight loves these guys.

[@jakestech28]

Thanks for the video, currently doing it to mine. Super, super messy.

[@stooucs]

On your website are 2 kinds of brass bushing available. Inner and outer, with different length. In the video we can see only one being replaced. Which one is used in the video? And what is the use of the other? Thank you

[@noahwise6938]

Can I wire wheel the knuckles and stuff like I did the axle? Why do you specify sand blasting?

[@vaioskaliakoudas6388]

Can I tighten the spindle studs to the knuckle with the dual crossthreaded nuts method like in the ball joint stud removal step???

[@tristancoonts2680]

How do the wiper seals go on man

[@isaacpaton2936]

Isn’t there meant to be grease packed into the steering knuckle

[@georgehennen4659]

Where does the dust guard go?

[@stevanrice5032]

What media do you recommend for sand blasting the knuckle housing and diffs?

[@spectacularviewapartment3583]

Hard to see this absolutely no-professional bush extraction. Normally should be used suitable extractor, no hammer.