How To Recover Recondition Dead LEAD ACID BATTERY 2024

#foryou #recondition #battery #batteries #2024
In supplying energy to a vehicle or device, a battery discharge process known as sulfation occurs. Sulfation is the formation or build-up of lead sulfate crystals on the surface and in the pores of the active material of the batteries' lead plates.
More crystals mean longer charging times, less efficiency, and lower charge capacity.

[@tktk7880]

احسنت ‏‪

[@mrinaladhikary6237]

😅battery acid name was not shown in bottle😅. But the way was accurate. Not all times you need to pull out the acid because sometimes their is nothing left😂😂. Manufacturing company don't put hudge acid. They put wet soaked tissue paper to separate the plates. Now that's is distilled water soaked into it. Not acid. Later they put 0.5ml maybe on each cell. Soaked distilled water gets evaporated over times. ************************************* I am now not talking more about companies. But what if? After putting acid you got 1 to 3vdc? ************************************* Any old, new, intelligent charger will not detect, because the 9v relay or 12v relay will not trip😂. Insufficient voltage. ******************* Go and buy a 12vdc minimum 20amps computer ups atx or smps(not adapter it will blow within minutes of use) connect it to the battery 20 to 30minutes. Now that power supply will boost battery voltage to 11.5vdc, which will be enough to trigger that relay of the charger. Now when the voltage reaches above 11v try charging with charger it will soon start taking charge. ********************************** Secondly many put some random salts😅 maybe epsom, lemon acid, distilled water, bathroom acid😂 what not? Bro you are damaging the battery directly but doing nothing. If you think distilled water will work try cut two wire now dip the naked wire in water see bulb will not glow its non conductive. Only acid is conductive but putting randam acid in it is dangerous😂 experiment. You can dip wire in acid and try litting a bulb it will glow but in salt solution also but the salt neutalize the chemistry of battery. *********************************** If you want safe revive of battery then use battery acid only other stuff just avoid. 😊 Thank You

[@canalulvulturului]

Thank you very much for your point of view. Through the process presented by me in this video for regenerating the battery. I am very pleased. For example, I use it for a spray atomizer and with one charge it works with 4 16 liter tanks (and when it was new with 5 tanks)

[@user-qe7xj9zd9u]

What can I say ? Just like him, he didn't say anything ! No dialogue, to me this wasn't very helpful !!!

[@canalulvulturului]

I hope it will be more useful for you now explaining the steps as you can see in the video: - check the battery with a 12 v bulb (the bulb does not light up - so the battery does not work) - unseal the battery with a cutter to reach the openings of each compartment. - remove the liquid inside with a syringe (if it still exists) - wash each compartment with hot water several times (depending on the color of the water removed) - leave the battery with the holes down to drain and dry, in my case it was 4 hours - fill each hole with electrolyte solution for batteries (a little above the lead) - I connected the battery to a charger - electronic rectifier with screen (so that every visitor can see the voltage) - in my case, this electronic charger - rectifier with screen was not useful for charging my battery, it had a very low voltage. Later I found out that most chargers - electronic rectifiers are not designed for such a thing. - in my video you can also see in the frame a charger - mechanical rectifier (old model), I managed to charge the battery that I reconditioned - and finally I reconnected the 12 v bulb, and it turned on. I hope that the video and the answer to your message will be useful to you. Thank you!