HOW TO REMOVE AND REPLACE HEADLIGHT ON MERCEDES W211

[@AutoRepairGuys]

Products that we use and recommend: ► Headlight: amzn.to/4fmcbRN ► Panel Removal Set: amzn.to/3YiMADu ► Assorted Fuses: amzn.to/4fx4s3F ► Tool Set: amzn.to/3p5MM6t ► Screwdriver Set: amzn.to/3XRB28Q ► Castrol Oil: amzn.to/3xBc8B9 ► Oil Filter: amzn.to/3w0Ulme ► Torque Wrench: amzn.to/32qyRwg ► Liqui Moly Engine Flush: amzn.to/3IiDBID ► OBD Scanner that we use most often: amzn.to/3I4MQfe ► Check out our Amazon Store for the tools and parts that we use: www.amazon.com/shop/worldmechanics

[@Titanic19127]

Auto Repair Guys do I have to do the same to replace just the lense?

[@shainert]

Thank you for your clip. Few Notes: - There is access to the 2 screws behind the bumper's grill from above (although without direct view) and from below after removing the bottom cover. It is better than breaking the fragile grill. - When pulling out the wide clip that holds the bumper on the side with the body, better not to push against the bumper. - And when returning it, first put the pin in the far end and pull it toward you until the clip screw hole is aligned with the bumper hole, only then push it to clip the whole length.

[@larryp85]

i was thinking that also. no need to remove the grill

[@rocketsalad]

What a journey, thank you for not editing this vid, very enjoyable to watch you figure out how to remove the bumper as you went along.

[@jordanhernandez2937]

Guys y'all really helped me out on this one. Thank you so much all the way from San Antonio Texas. Started at noon and got done around 1:30pm and that included going back to your video step by step. Thanks again

[@MrCreepermax16]

I watched this video a few times before attempting this myself and the entire process was flawless. A few things to note, you don't need to remove the plastic cover on the bottom of the car to access the hidden bolts holding on the bumper, removing both front wheels makes this way easier, and you "need" to buy a special tool to remove the plastic rivets. Overall I would rate this a 4.5/10 difficulty if you're using power tools

[@johnjamesmoses]

Thanks, really helpful, W211 owner, New Zealand

[@sayhellowavegoodbye]

vielen herzlichen Dank für die ausführliche und gute Anleitung zum Ausbau des Frontscheinwerfers beim w211.

[@davidschmitt7079]

Great video guys! After I watched it, I was able to completely remove the front bumper assembly and right headlight to troubleshoot a wiring issue with the right parking lamp. One thing I would add is you probably need a set of Mercedes pry tools for the plastic fasteners in and around the wheel well.

[@abrahamofek4485]

A very good description for ke, thank you 🙏🙏🙏🙏🙏🙏🙏

[@ScottEdwardLogan-SAGAFTRA]

Excellent job, Gentlemen. Very good instructions and follow through. I have a 2006 E350 and the Headlight wire harness needs to be replaced, as all the insulation has dry rotted off, exposing the wires. So my low beams don't work. I bought the wires to replce them, but getting to the harness looks to be a pain.

[@ameixsell]

my friend is having a similar problem, did the lights flicker when they turned on and the would turn off? the running lights and passenger side headlight doesn't work after it flickers. how did you replace the harness?

[@haleiwahi27]

This is a great video for the headlight assembly removal. I just wish the Auto Repair Guys would monitor the site and respond to the questions asked below. I have similar questions, but no sense ask them if there are no responses.

[@manfromatlants]

Hello, Thank you sooo much for this video. Can you please make a video about the front turn signal failing coz plastic melt on it and there is no connection. I see in this video you did 2 wires to the right front turn signal. Plz explain how did you do that? Thank you so much.

[@wolfjamezz4293]

Yo, such a awesome video! Showed how to replace the headlights & the bumper! Thank you! Good dudes!

[@adnanali1595]

Hi, does this particular car have the ABS? My w211 has it, and I was told the bumper needs to be removed in order to change headlight?

[@dahvilk4]

Hey repair guys. I have a question for u? I have a 02 cl500. I have no readings on my instrument panel. The car came with no fuse diagram. And after pulling cluster out i noticed one bulb missing. However i have no communication with info panel. What do i do? Is it a fuse prob? or bulb?

[@dahvilk4]

Also this 02 cl500 has a lag start up. When i turn key to start position, it doesn't do anything then seconds later by leaving key in that start position it cranks up, sumtimes it do sumtimes it don't??. Is this a sign the battery is going bad or starting going out?

[@jonlee7209]

OKC THUNDER!!!! Best team ever!!!!

[@tomcruise11880]

Thank you guys for the video. This is very helpful!!

[@TheUroy501]

i want to ask if the uel E10 is compatible with merdedes benz E240 , 2004 modern

[@Whatyouwanttoknow63]

You have helped me a lot man, thank you so much. I have a question, does headlights have a relay? I've been trying to find it, I also have an w211, e320

[@boombags6094]

Hello, i have a mercedes C180 Kompressor 2005. The SRS Airbag light is on and it says passenger airbag is off. I dont know how to turn it off. Can you please help me fix it? Thank you!

[@alanduqu]

You did not show the connecting fastener that you removed from the back of the bottom location on the headlight. Bummer since that is the whole reason I watched the video. I seem to have lost mine and wanted to know what could possibly cover such a large hole in the frame.

[@escaladeEXTon28s]

When did Borat start working on cars? Verrry niiice

[@andrewconnolly7169]

Lads ye are brilliant, thanks for all the advice

[@ruhsatigoek1632]

Good video 👍

[@miguelcruz-lg3gq]

Thank you guys God bless you

[@JOSELUISGARCIA2827]

Pues si tengo un mercedes clase E del 2006 cdi avantgare W211 y quisiera cambiarle las luces de posición delanteras por unas led que den la luz blanca y un poco más intensa. A la hora de quitarlas he visto que tiene un conector que sale pero cómo se quita la bombilla, hay un tubo que está dentro la bombilla pero está fijo con la bombilla dentro le he puesto otra vez el conector y no se cómo quitar la bombilla en cuestión para cambiarla.

[@stefanm.4416]

It´s totally unnecessary to remove the black plastic of the bumper. Everything is acessable from below. All you do by this is wasting time and ruin the bumper...

[@highlandswebclass]

Stefan M. Is it possible to do without removing the bumper?

[@tequilashots875]

Marcel Yochanan no

[@MrMishka212]

why u have to remove bumper for a headlights,miss my BMW

[@bipedalbob]

That alone would prevent me from owning a high priced piece o crap car like that.

[@cristian50184]

Piece of crap? 🤣🤣 that one is one of the best engines that Mercedes has, are you kidding?

[@bipedalbob]

@@cristian50184 not dissing the engine I'm dissing the car itself Your opinion of the engine is debatable, what is your criteria for thinking it's one of the best, probably not the same ad mine and many others. Mine are, it's a car, what's it's purpose. To get me from A to B and back again. My first concideration would be which one will provide the most miles per dollar spent. Then would probably be comfort, most motorcycles will take you farther on a dollars worth of gas but not so good on a rainy day. But if your criteria is more towards trying to make an impression on others your choice would be vastly different.

[@cristian50184]

Yeah everyone has a different opinion but If i don't talk if I dont know , so let me tell you , I'm a Mercedes technician working in all type of Mercedes 7 to 5 Monday to Friday, second I own a 09 e350 w211 platform , of course I work on it like any other car I have so basically that's how I know is one of the best car and engines that Mercedes has like I know anything from 17 -up is garbage.

[@bipedalbob]

@@cristian50184 what is you criteria for best, just cause you a mecedes tech mean , I'd bet a RR tech thinks your full of it, probably even a Honda tech.

[@sageseventh]

Good video but anyone watching this with a w211 e63, it’s not the same. I pulled back the plastic to find out there was another metal wheel well beneath it. Just FYI

[@noriborre8356]

Thank You

[@pgsboy]

After watching this I’ll let the pros do it

[@1121fatboy]

😂😂😂😂😂

[@notmybytch2606]

I like to wear a nice pair of gently used socks when I work on my w211.

[@ninofarhan9807]

Notmy Bytch wtf lol

[@thomasrose6962]

Not my bitch. That’s just sick. But working on these will make u think sick. Sick things the mb engineer must have smoked when he was designing some of this what used to be simple stuff

[@bosnjak19]

Even on junkyard people watching this gay..heheh thank you

[@pryceh7895]

he talks like he has water in his mouth

[@kdimov1984]

Both of you guys wears martenitsa, why?

[@wiseman007100]

O.M.G really all that lol..just take it to a mechanic!

[@jasonhitch660]

I am NOT removing the bumper cover for the frickin headlight.

[@rocketsalad]

I guess you’re not getting your headlight out then 🤷‍♂️

[@kevinkev1530]

👍🏾👍🏾👍🏾👍🏾

[@sayeedsajjadhossain3316]

U started with a mess!!😂

[@iluvucuzjesus5347]

this is why german engineering sucks

[@JOSELUISGARCIA2827]

Pues si tengo un mercedes clase E del 2006 cdi avantgare W211 y quisiera cambiarle las luces de posición delanteras por unas led que den la luz blanca y un poco más intensa. A la hora de quitarlas he visto que tiene un conector que sale pero cómo se quita la bombilla, hay un tubo que está dentro la bombilla pero está fijo con la bombilla dentro le he puesto otra vez el conector y no se cómo quitar la bombilla en cuestión para cambiarla.

[@MrKingNica]

Thank you

[@abrahamofek4485]

Thank you