How To Remove Front SeatBelt Buckle Receiver & Seats On Honda Accord | DIY Auto Repair & Fix Guide

In this video, young mechanic Aiman will show you how to remove the front seatbelt buckle / receiver as well as how to remove the front driver and passenger seats on a 2004 Honda Accord (which is the same for Accord model years 2003, 2005, 2006 & 2007 DX LX EX 2.4L & 3.0L engine).
The removal, replacement and installation process should be the same for most Honda and Acura cars such as Civic, Element, CRV, Pilot and Odyssey.
Thanks for watching. There are many more DIY instructional videos & step-by-step guide already published by young mechanic Aiman but there are many more automotive how-to fix, remove, replace and install videos that have yet to be uploaded onto his channel, especially since he is dismantling his Honda Accord in order to help give you ideas on how to fix or repair you cars, vehicles, minivans and SUVs.
This video is presented to you by young mechanic Aiman-Imran Zulhilmi Anuar. Please be sure to watch other DIY auto repair videos on Aiman's EyeOnAiman youtube channel & facebook page.
Disclaimer of Liability (No Responsibility): Please exercise due diligence with information obtained from this video. The information contained in this video is for entertainment purposes and should only be treated as such. I shall not be held liable for any damage to vehicles, tools, equipment or person resulted therein. This channel assumes no liability for property damage or injury incurred. You will use such information at your own risk. Aiman recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Any injury, damage or loss resulted from using information in this video is the sole responsibility of the user and not EyeOnAiman.
~EyeOnAiman KZbin Channel~
Recording Date: September 3, 2018
Video URL: • How To Remove Front Se...

[@joshuamoriarty5698]

Thank you, i needed this to fully detail my car!

[@adeelzafar5674]

Same reason I am here!

[@Steven_R_]

Same😂

[@bootyslayer_6967]

Same !

[@1BRWNSKN]

Same 🙂👍🏽

[@kriespylon]

YESSS. THANK YOU. THIS IS THE VIDEO NOBODY ELSE CAN MAKE 🙏🏾🙏🏾🙏🏾🙏🏾

[@kseries20-24only]

Don't forget to disconnect the battery! Anything with the yellow plugs deals with airbags 😶

[@swansong487]

Was about to comment the same thing!

[@orbihx]

thanks bro

[@LavekGaming]

Biig legend 🙌 thank you

[@fifamatches1058]

Bro you remind me of me when I was a kid. Good job

[@dannydee9919]

Hell yea. My favorite you tube diyer! I just saw your video on how to staighten front of the car after collision. You rock youngster

[@stevegier3871]

Very nice work -- this helps me know how to do my Honda Pilot seat. Props and thanks!

[@sbreagle]

Nice job!

[@hydewizard]

An American named Aiman. A very typical Malaysian name here. Thanks for the tutorial!

[@psychoblondi]

Great video! To the point, easy to follow, good energy and information. Thanks!

[@apedog999]

some other video said that some of the wires on the bottom are for the side air bag and that you should disconnect the batter before removing the clips. something to maybe think about if you do this

[@noemivielman3877]

Very helpful thanks

[@muhammadqasim4275]

Nice work. Isn't it a good idea to remove the negative terminal of the battery before unplugging wires?

[@joshuamoriarty5698]

There are no super unsafe live wires popping out, those caps he presses to get them out contain them so you should be ok unless you dont have them

[@EldenTriLee]

@@joshuamoriarty5698 I assume they are seatbelt and weight sensor/airbag wires. Could unplugging them cause an issue with the airbag system? I just need to clean underneath so I won't unplugged them anyway.

[@goognamgoognw6637]

Great video, especially since I've got the exact same car. :D

[@EyeOnAiman]

Thanks!!!

[@kriespylon]

I NEEDED THIS

[@EyeOnAiman]

Thank you!!!

[@michaelkowalski8507]

awesome video! Very informative.

[@yesenialopez1210]

Ahhhhh I neeed this! Thank you!

[@harbansbhola7853]

Nice video kid thank you and the person who is helping you 😊😊😊😊LOT of Love be careful when you handle all this things and lots of BLESS 😊😊😊😊😊😊

[@ashtonvalentine7496]

Awesome vid man very helpful

[@Minxviral1]

You are awesome 😎 can’t wait to take the seats out my car

[@kathyboody6206]

Me too! I need to deep clean it, this makes that a breeze and so much easier to achieve full cleaning :)

[@Whatthehell1999]

Thanks

[@captainnaveed3781]

Thanks for very much informative videos. I have a problem with the driver’s side electric seat of Accord 2004, while adjusting its back it feels on right side after reaching to certain position. I’m not sure but looks like there is an issue with the right-side joint which connects seat and its back. Any help? Thanks

[@richardcruz4726]

Great video little man

[@TheBiggcam]

Thanks bro!

[@KRISTIANFIGUEROA123]

Lol Nice work kid good video

[@user-nn9di2vq8h]

How you change the bolt on it to remove from bracket

[@Makingfinancialdecisions]

Good job kid! Great video keep up the content.

[@gregwalker1740]

Can you drive the car without seat installed?

[@2004hondacivichybrid]

You are so amazing, thank you:)

[@EyeOnAiman]

Thank you, I appreciate it! :)

[@adhamali5935]

Thank you sir

[@goldinthefurnace]

Thank you dawg. I'm broke as hell I'm trying to get these few quarters under here 😢..😂😂😂😂 might as well clean this MF too 👍🏾

[@shubhjotmaan6989]

Is that 1/4 14mm socket?

[@oweup]

Can you link the tools you are using

[@TheAguilarFamilia]

Good video!

[@Courage2Care]

Hold it like a bride 👰‍♀ 😂😂☝️☝️🤣🤣🤣🤣🤣

[@chuck50a]

Could you avoid removing the seat by removing the seat side cover, unbolting the seat belt receiver and then snake the new control cord under the seat to the electric plug?

[@rkmlb5005]

You didn’t mention the bolts holding the seatbelt, that’s like the most important part lol

[@aayushgupta2154]

he's the "weight reduction bro!" kind😂😂

[@user-hg8uu7lj9p]

Thanks bro 👍 lol.

[@MaelFam]

Very informative. Thanks much brother 😄

[@whogavehimafork]

"Hold it like a bride" *gets stuck* "A very wide bride"

[@JohnDoe-we9dd]

Your Milwaukee may not be strong enough but mine is 😂😂😂

[@p_fiction]

No worries lil bro, those "bolts" have a technical name and that is "hex head cap screws" ...so you're fine calling them screws...or play it safe and call them fasteners like you were doing. One small thing, for me personally anyway, I'd rather hear you call the socket "14mm" rather than "#14". If you're under the hood of a vehicle and said "hey pass me that #10 wrench, I'd definitely be looking at you funny lol. But if you say hey pass me that 10 millimeter wrench, Id know exactly what you want.

[@1BRWNSKN]

😂 "A very wide bride"

[@edgarbarrera-realestatemor2550]

🙏🏾🙏🏾🙏🏾

[@slew12]

LIKE A BRIDE 🤣 A LITTLE WIDE ONE 🤣🤣🤣🤣

[@davidlevy990]

Can you please do a video to replace the driver side "bottom" seat for a Honda Accord LX. The seat is a power seat. My bottom seat cushion is ripped and is showing the inside foam. Thanks in advance. If you can, please let me know if you can hit me up on email

[@paulrush9166]

Fun fact: Aiman is really 48.

[@gooblysgaming287]

You're gonna break everything

[@accordingly5342]

Very wide bride 😂

[@daviderhahon]

A very wide bride... 😁😁😁

[@umeasorchijioke4988]

Big bride 😂

[@adambaum9732]

When he was calling the bolts "screws" this led me to think that if this kid who doesn't know a "screw" from a bolt can do this, ANYONE can do this job.

[@1BRWNSKN]

🤨 Really?.....You're petty 🙄

[@soulloww2752]

Should of fold the seat Back 😂