How to replace bearings in an FPV / Drone electric Motor || Hyperlite type motor

This is an in depth bearing change on a Hyperlite 2307 / 2522 Electric Motor. Followed by Tips and Other Motors after the 6min. mark.
I made this video to give viewers an in depth look at changing bearings on electric motors without using a press. Listed below is a description of the Bolts ,nuts, and washers you will need to make your own tool to press in the bearings.
1-30mm Long M3 thread bolt. Head can be Screw, bolt, or allen head.
1-M3 thread Nut for M3 the Bolt
2- Washers slightly wider than your bearings. In this case 9mm wide
2-Washers slightly smaller in diameter. In this case 8mm wide. The 8mm wide washers help distribute pressure from the Nut and driver across the larger washer and bearing surface.
(made with #spliceapp - get.spliceapp.com)

[@mregor111111]

You have a good skills and good explanation that even me from russia with my bad english, i get everything yiu told

[@BariFPV]

I really liked how you used the screw to seat the bearings! Brilliant mate👍

[@reaganleejobe]

Thanks Bari! Glad you liked it. Keep ripping brother!

[@deadstickfpv]

Helps if you want to get ride of jello

[@QuadFarm]

that's pretty slick.

[@reaganleejobe]

Thank You, I appreciate the feedback.

[@JC-zg2id]

Would u recommend people use small hammer screwdrivers to take out the bearings?

[@reaganleejobe]

JC250 in the video I use a very small flat head screwdriver and hammer to punch them out. Be careful you are on the bearing and not the center aluminum. 👍

[@LumpyFPV]

Good technique bro!! Thanks for this vidya. 🤌🏻

[@glytch5]

RED loctite for that? I guess if you never want them back out. I tried this with some eachine motors, they use some weird super thin locking ring in there which made tapping out the original bearings nearly impossible without an actual press, you just about almost destroy the stator doing so.

[@reaganleejobe]

That’s why you use the soldering iron to heat up the bolt so the red Loctite releases.

[@neilfpv]

Great tips! Where can I buy bearings for my BrotherHobby R6 2207 motors?

[@reaganleejobe]

Neil Camara Most people that sell motors sell replacement bearings. First you need to know the size of the bearing which is measured in millimeters. Measured in width and height. So how many millimeters the bearing is across and how many millimeters the bearing is tall. I have some 2306 brother hobby motors. They are 9 mm wide. I’m not sure about the height. I will pull one apart this evening and get back to you on the height. Thanks

[@neilfpv]

@@reaganleejobe I found out the size of my motors yesterday. It's 9x9x4. I ordered 10 pieces for a total of $9. Not bad. It will arrive on May 12. Thank you!