How to Replace Brake Kit 99-04 Honda Odyssey

Buy Now!
New Brake Pad & Rotor Kit from 1AAuto.com 1aau.to/ia/1ABFS00855
1A Auto shows you how to repair, install, fix, change or replace your own worn, squeaky, fading old front brakes. This video is applicable to 1999-2004 Honda Odyssey models.
This process should be similar on the following vehicles:
1999 Honda Odyssey
2000 Honda Odyssey
2001 Honda Odyssey
2002 Honda Odyssey
2003 Honda Odyssey
2004 Honda Odyssey
🔧 List of tools used:
• Impact Screwdriver 1aau.to/oN/1AXAA00047
• 14mm Socket 1aau.to/oBb/1AXAA00015
• 18mm Socket 1aau.to/om7/1AXAA00043
• 19mm Socket 1aau.to/om7/1AXAA00043
• Lug Wrench
• 1/2 Inch Breaker Bar 1aau.to/ocH/1AXAA00078
• A Piece of Pipe (for leverage)
• Ratchet 1aau.to/oDH/1AXAA00016
• Torque Wrench 1aau.to/ory/1AXAA00044
• 1/4 Inch Drill Bit 1aau.to/oz/1AXAA00092
• Drill
• Floor Jack 1aau.to/oi5/1AXAA00068
• Hammer 1aau.to/ohP/1AXAA00091
• Jack Stands 1aau.to/oie/1AXAA00065
• Large C-Clamp
Subscribe: / @1aauto
Check out our playlist:
Honda Odyssey 1999-2004 2nd Gen: • Honda Odyssey 1999-200...
How to Replace Brakes with Parts from 1AAuto.com: • How to Replace Brakes ...
For More Info visit us at 1aau.to/h/QW/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@1AAuto]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

[@AbeAlexander]

Kudos to you guys for showing the the screw strip problem. Not only was it honest as hell, but very useful for the many that are going to run into the very same problem. Nice going.

[@austinhernandez2716]

I just bought full brake set from this website for my odyssey. Hopefully they will be good quality.

[@1AAuto]

We'll keep this request in mind in the event that we need to make this repair on this particular year Honda Odyssey. We do carry a nice brake pad and rotor kit for it on our website 1aauto.com Part Number: 1ABFS00883 888-844-3393

[@marthar4370]

Thank you...saved us $1300 in repairs doing it ourselves.

[@1AAuto]

Thank you for the great reply. We love to empower our customers by showing you how-to perform your own auto repairs while installing our high quality auto parts. Have a great day! 1aauto.com +Martha R

[@1AAuto]

@Bino Santi If you follow the steps taken in this video, you should be fine.

[@1AAuto]

You may want to check the catalytic convertor to see if it's clogged, if it happens afte rthe truck heats up. Also check for a loose or corroded connection to the battery and this may also be causing your issue.

[@johndias6614]

I was surprised you didn't grease the slide contact points and the pad backs to minimize squealing. Also didn't show the placement of the wear indicator.

[@robertgpenrique9302]

Good I like what you did. I have same Honda 2003 and. Know is very easy to fix mil veces thanks.

[@stevetilbrook3402]

I never worry about grooving, pads will seat in and grip fine

[@briantedlos1804]

Great Video! Are you going to have a video for how to replace Motor mounts and bushing for Odyssey 99-04?

[@ramialshobaki]

thanks for this great and easy to follow video

[@1AAuto]

+Rami Al-Shoubaki No problem. Thank you for watching. 1aauto.com 866-403-3393

[@Zorrobama]

Great video.... you take all the fear way....

[@58heriberto]

Great video .. Can you do one for a honda odyssey 2007 brake pads and rotors?

[@marcobro8153]

Thanks for you help, thanks for post this video

[@1AAuto]

Thanks for watching. 1aauto.com

[@marunio1]

Thank You!!!

[@1AAuto]

HI Shaun, You may want to pull the code from the computer, that should tell you exactly what has failed and is causing the light(s) to come on.

[@franksharkie980]

Good vid, however when removing the two bolts to take off the caliper, you will sometimes you need an additional wrench to remove the outer bolt.

[@1AAuto]

Yes it's always a very good idea to wear eye protection.

[@norcoextreme666]

hi there, like your vids, i have a 2005 grand caravan and the abs, brake, and trac off lights are on. the brakes still work but i dont know why those lights are on?

[@luisarocko8433]

Do you have any 05 to 10 Honda Odyssey videos

[@tonytoneton2pac966]

Do you half to put that pin on for the top brake pad in,guessing to let you no the calibers almost done?

[@johnshanahan6439]

You didn't mention the lock nuts on the caliper bolts. Also, you didn't open the bleeder valve when you collapsed the caliper piston. Aren't you worried about blowing the piston boot out when you depress the piston? Just curious.

[@eaglecompany6220]

How can I replece my transmission speed sensor fron my 2001 honda odyssey

[@kevintillack1396]

The dealership sells the rotor screws for cheap

[@chino26w]

great videos they are very helpful. I have a question about the red light on the dashboard "BRAKE" it turned on so I replaced the front brakes and rotors. But the light is still on how can i erase it? thanks in advance for the help.

[@1AAuto]

+Ignacio Arreola Lights like that typically need to be reset, and the owner's manual should tell you how to do it!

[@chino26w]

thank you

[@benyku82]

I have a 2003 Odyssey that had this light come on. If it's the one below the door ajar symbol, that usually means one of the rear brake lights are out.

[@1AAuto]

You may have a burnt our light on the left side of the vehicle. Usually this is why the turn signal doesn't blink. Check the turn signal and brake light bulbs to see if they're blown, and need to be replaced. Hope this helps you out. 1aauto.com 888-844-3393

[@SonsExistenciais]

Você não lixou e limpou o cubo porque não e preciso ou neste caso não foi necessário? Obrigado.

[@V11P11R11]

I saw ur video a minute ago but not for this one. For another for replacing your signal stick for lights. My question is. Is it the stick? Or is it the light? When i puy my signal to the right it flickers fine and give signal. But when i do it to the left. My signal light stays on and doesnt fliker the signal that im turning left.......... help?

[@ivosimon5087]

Don't you need to open the brake cylinder cap when pushing in the piston on the brake caliper so that air doesn't get trapped in the line?

[@1AAuto]

+Ivo Simon You can if you would like to, it's not necessary

[@Svyatoslav226]

💯

[@7theinfamus4]

Not sure but hope you will respond. You did not mention anything about, bleeding, the brakes. Is that necessary or not? Thanks for the video

[@7theinfamus4]

thank you both very much for the help. I appreciate this channel very much

[@falconone9283]

Do you guys ship to Guam? We are a U.S. Territory similar to Puerto Rico and is serviced by the U.S. Postal Services.

[@1AAuto]

+Falcon One Thank you for watching! We do ship to Guam, but it depends on what you are ordering. Something like a brake set may not be eligible for shipment there, but if you have any questions give our customer service center a call at 888-844-3393! You can also chat or email through the website. 1aauto.com

[@thnguyen92003]

Hello, what is the good Grease to use for caliper guide pin

[@1AAuto]

+T Nguyen You can purchase caliper pin grease at your local auto parts store. Hope this helps you out. Thanks for watching. 1aauto.com

[@DumpinMyGun]

Anyone know how to change a front broke lug bolt for an 03 Odyssey?

[@1AAuto]

Thank you for watching. Unfortunately we do not have a video for your application. We will keep this repair in mind for future videos. 1aauto.com 888-844-3393

[@gonzo6110]

like to know why truck keeps stopping on me after driving 2 miles, and then it starts after I wait 30 minutes again, changed fuel pump and filter,

[@richardhellmers8727]

That blue odyssey must be new again

[@boohoo210]

U said 17mm bolts in the video but 18mm in parts list. I believe they should be 18mm

[@nostradukemas]

If my rotors appear to be in good shape and my pads are only worn, can I just replace my pads?

[@1AAuto]

HI Justin, Sure, if the rotors are in good condition you can just replace the pads. Here's a link on our website to them we also offer FREE SHIPPING on all orders in the lower 48 states. www.1aauto.com/1A/brake-pads/Honda/Odyssey/-/-/1999?VideoReply&VideoReply&ATony

[@sameralhabbal4758]

very helpful if you cannot pay the mechanic bill

[@juanokiller]

Samer Alhabbal is not about , not being able to pay a mechanic, some ppl like me like to be handy and do work when ever is possible...

[@1AAuto]

If we need to make this repair in the future we'll keep this request in mind. 1aauto.com 888-844-3393

[@nexus1g]

I have a sticking caliper on the passenger side, and you don't see that you sell a rebuilding kit nor the calipers themselves for an '02 Honda Odyssey.

[@1AAuto]

+nexus1g We do not carry calipers for your vehicle. Thanks for checking us out. 1aauto.com

[@nexus1g]

@@1AAuto Thanks for verifying that.

[@randyschmidt23]

Do u have to bleed the brakes?

[@1AAuto]

+Randy Schmidt As long as you do not remove the brake lines or open the bleeder screws you will not need to bleed the brakes. Thanks for checking us out! 1AAuto.com

[@randyschmidt23]

@@1AAuto thanks for the fast reply!!