How to Replace Control Arm With Ball joint 2006-2013 Chevrolet Impala

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@ocmichelli8580]

Thankful for your videos been working on my 08 impala all week and you’re the only one who goes into enough detail.

[@optic1152]

So…. How’d you get the ball joint out the knuckle??

[@jgt9338]

My new control arms say "Avoid premature bushing wear. Do not fully tighten bushing until suspension is at ride height." What are your thoughts?

[@ColdWarVet607]

Nice job!!! I was trying to get the control arm back in and realized the strut is forcing it short of mounting the bolts. Im like "how they do this", then Im like "duh...a strap" Thanks...I'm a bit stupid today!

[@gangar4098]

Changed the sway bar i see as well at the end, nice

[@DDMEGADUDU85]

How did you torque down the ball joint nut never seen it

[@deanohocampo2757]

Thanx for this video. Im doin it myself got all my parts. So ill comment again once its all done.

[@TRQ]

+DeanOh Ocampo Thanks for the feedback! 1aau.to/m/Shop-TRQ

[@TonySmith-H-Town_83.Detailer]

So i think i didn't tight to bolt to tight but i got the pin through will that be a problem its pretty

[@ampecsu]

pre load?

[@chhansen9813]

Why would you need an alignment done, you didnt touch the tie rods?

[@TRQ]

+ch hansen It is always suggested to have an alignment performed after replacing any suspension parts for optimal performance.

[@123renfroe52]

Great job!

[@ryanhite4488]

Can I get this tight enough without an air ratchet?

[@muhammadrehan6126]

Good information

[@sigasmund]

I need to replace the plastic harness fasteners.

[@MrGariepy]

no camber?

[@coloradoking4240]

Mann how you took the tire off in a circle made me cringe always use a star pattern 😐

[@GeneralZho]

7:46 yeah right buddy your not that strong 😂😂😂

[@CleanConnect-ge9th]

You jump into everything and never say what size bolt

[@ghettobrown209]

Never even greased the ball joint I got the same a arm I was looking for the grease info

[@ilovepizza8263]

this isnt even an impala in the video