How to Replace Distributor 1995-2000 Chevy Tahoe

[@TRQ]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*

[@timbosims4397]

Not the best install video for those seeking guidance...when replacing a vortec v8 distributor follow these tips 1. Remove cap and plug wires and cam sensor connector at rear of distributor 2. Remove distributor. hold bolt and clamp 3. Remove distributor via the distributor body (not the rotor) allowing the rotor to move ccw as it follows the driven gear up and out. REPLACEMENT 1. Set number 1 cyl. to TDC, When I work alone I use a 2 ft. length of hose to stab into spark plug hole and put other end in my mouth allowing me both hands to turn the crank until it begins to inflate my mouth confirming I'm at TDC on the compression stroke then I refer to the line on the crank and notch on engine and continue turning the crank slowly until they line up. 2. With distributor in hand as a close reference I put the cam sensor at about 2 o'clock and the rotor pointing at about 3 or 330 just as a preliminary setting 3. Notice the flat spot on the distributor. Housing, this should be somewhat parallel with the lower intake housing after distributor is down so again after you allow the driven gear to pull the rotor clockwise and when the distributor is set your two landmarks are A. The distributor. body flat area should be close to parallel with the intake B. The rotor should be pointing to the no.1 cylinder and you should have it but let me inform you on a vortec this is just a base setting and an engine scanner with "cam retard" capability to fine tune turn the distributor to + or - 2 degrees as per spec.....if any more than this you'll probably get your po1345 code back....hope this helps yall

[@timbosims4397]

As far as the distributor sitting down all the way don't worry about that if it doesn't seat down all the way but lines up to no. 1 your good....the gears have meshed all u need to do is slowly turn the crank and soon the distributor will "drop" into place then clamper down

[@wilsonwells8502]

For a person who has never done this before there is no mention of tools needed it would have helped a lot

[@dannybriggs4114]

So what did you do between 5:20-5:25 to align the rotor to your yellow mark? Did you have to lift the distributor back out and retry so when the gear pivots it aligns to the yellow mark? Or did I miss something?

[@MacAutoDiag]

I love how they didn't show that part because it's hard to do lol

[@mydamhouse]

What size bolt was on the distributor mounting bracket?

[@ronspencer676]

I just installed a new distributor. Top dead center on compression stroke as it should be. Rotor pointing towards the #1 cylinder as it should be But my obd reader says the timing advance is negative 24 and vacuum is negative 19. It starts good and runs ok... but i feel like something is wrong. Am i a tooth off?

[@leviriordan7183]

Did it start??

[@elnino2410]

follow up on these questions are just like the problems in these engines

[@thomasdemarco617]

what about cam offset timing

[@AW-fb8hr]

he never took the axle nut off in the first place

[@MacAutoDiag]

Do not follow TRQ videos you will fail. They cut corners on their videos

[@davidporcell1480]

Mines started leaking on top made big mess

[@Mvasqu25]

Why not leave it the way it was?