How to Replace Door Latch Assembly 1994-2004 Chevy S-10

[@TRQ]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Shop-TRQ-Parts √ *Do it Yourself* √ *Save Money*

[@rogerwachal3718]

No results found for "Door Latch Assembly", on a 2000 Blazer Chevrolet

[@dandavis9071]

Such a clear, concise video. If there were an Oscar award for instructional videos, you would take home the trophy

[@dialdude]

I am about to do this on my S10, with 330,000 miles. Not surprised it broke, but your video shows me EXACTLY how to do it. Great video and explanations. Thank you so much.

[@jwheatley1209]

Thank you. Helped me out so much! And saved me money doing it myself!

[@johnwaltrowski8855]

Very good clear instructions. Easy to.understandn very good video also. This is the best instructional video on You Tube. Thank you. P.s This does work on a 2001 blazer.

[@mattnuttall545]

100% Went to the junkyard and used a trailblazer door for my S10

[@mcalife1707]

Excelent vid. My 98 Blazer dome and floor lights stay on while driving. Thinking it’s somewhere in that switch but after seeing this, if I can’t diagnose I’m going to pull the bulbs….

[@TRQ]

+MCAlife Thanks for watching our video! 1aau.to/m/Shop-TRQ

[@ethandunlap6755]

definitely needed this. My door locks barely work should I just do the motors or save for the actual latch assembly? my phobe for door locks also is broken so can I program in a new one without it?

[@mattnuttall545]

Thank you for posting this.

[@klxcountry]

This is INSANELY complicated. I will just cut the door off.

[@jimmyrustles3122]

I have a 2004 blazer and just recently replaced the locking mechanism. In the video it shows 3 electrical connectors but my car only has 2 but the locking mechanism had 3 electrical ports as well. I did buy this car used to I'm wondering if the electrical connectors were replaced or if it's fine to have only two?

[@scootersonlyrepair510]

The steps are the same but parts are very different. I just put s driver door of a 2000 bla,er on my 2003 s10. I had to change lots of parts inside the door .the wiring was different ,because it was a 4 door blazer and the latch is different my latch has 1 harness that plugs into it. The blazer latch had 2 harnesses so I had to swap it.

[@jovo8977]

What size are the 2 bolts that hold the outside handle in place? I lost one and the handle feels like its coming off

[@HardCoreGarage]

Great informational video!

[@yourstruly5146]

does this work for 01 chevy blazer?

[@CGTV1.]

It would. Same base vehicle with the same interior.

[@kodywillkomm668]

What is part number for door latch

[@IsaacCruz-om2ic]

I’ve done this and my latch still does not close with a new door latch

[@daledanowski9962]

thanks