How to Replace Door Latch Chevy Silverado 07-09

[@1AAuto]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

[@scottmcarthur3244]

Thank you for the video! Note that when putting the panel back on, at about 17:50 in the video, make sure to first install the ball end of the cable into the interior door handle mechanism.

[@1AAuto]

+Scott McArthur Thanks for the tip!

[@lisagentry6136]

impressive. and glad you spent time showing each detail. Now to decide if I want to tackle this myself or go to a mechanic

[@bryanmassa8699]

Is the electrical connector on that door latch for the sensor that detects if the door is shut? Or is it to unlock the door with a FOB?

[@frankguerrero8568]

If I were to replace all 4, would I be needing to program anything or would I just need to reprogram the key fob

[@jeremyhickman4084]

Just installed new actuator. It worked with door open a few times. Then I tested opening and closing door and was successful. Closed and locked door with the fob. Unlocked it and it wont open again. It should be noted that someone popped my key lock so it isn't connected inside. It has worked this way for 3 years until this week.

[@jeremyhickman4084]

Any help is appreciated

[@bartwoods-n5e]

I am looking for a how to for a 2011 Silverado ext. cab rear door wont open video. Any help would be appreciated.

[@zthayoungan1661]

Helpful video but for the red clip rod you just pull it toward you. And it should come out, no need for a pick.

[@WalkerRanger5]

I have a 08 and trying figure out why my new actuator is not working. Fueses for power un lock and power lock 10, and 11. I pulled and are good . Ive un plugged and plugged the actuator and unplugged to make sure of getting good connections. 08 ext cab 2x4 5.3 lt Silverado

[@SG-bb8pq]

Did yall figure out the problem?

[@stevenzwolinski1218]

Just had the same problem. Had power at the fuse box but not at the actuator. Trace the wires up through the door into the boot. I had a broken tan wire in the door boot. Put a butt connector and heat shrink on it and good to go

[@rambo1996rv]

@@stevenzwolinski1218 what's the boot? I've replaced mine. It works but doesn't lock or unlock. I'm a mechanic in learning from KZbin University

[@weldonsavoie3613]

Man what a pain in the you know what , I go by a new door , lol

[@jfhunt]

I noticed you said "almost" when trying to pick the linkage from the key. You were not successful. I would have liked to see the technique that WAS successful. That is the part I am having trouble with. The video was incomplete. Did you end up simply breaking the little red clip off and then need to buy a new clip?! I'm curious ....

[@bibbhccbibbhcc2493]

Just when I was trying to push the exterior lock rod out of the red clip and was about to stop due to fear of breaking… it popped out😅. Thank God it didn’t break and I was able to push it back in with no trouble. I don’t know if you can get just the red clip. Wouldn’t be bad idea to have one handy. Maybe could get one at a pull a part

[@mamz1404]

اللهم صل وسلم وبارك على عبدك ورسولك محمدﷺ

[@dagoatgully3186]

some of my door locks jam i’m trying to learn how to fix them. Dealership charging too much, $350 for each door.

[@edmills6099]

May as well change the speakers while you’re in there,mine were junk.

[@1AAuto]

+ed mills Thanks for the tip!

[@lguzman123009]

I replaced mine they work fine the only thing is that when I open the door my dome lights will not turn on with the old one it did

[@TrustyShade]

Do you have a video that will work for a GMC xl year 2000

[@1AAuto]

+TrustyShade We're always cycling through common cars. We'll add this repair to our list! 1aau.to/m/Shop-1AAuto-c

[@TrustyShade]

@@1AAuto thank you

[@Valita05]

You never connect the cable that open the door to the panel 🤔🤨🤨🤨

[@jamiefallon2810]

How do you replace Chevy 2007 silverado door speakers

[@1AAuto]

+Jamie Fallon We do not have a video for this repair right now, but we'll keep this request in mind for a future video! 1aau.to/m/Shop-1AAuto-c

[@slikk325]

What if the door is closed and you can’t open it from the outside do you cut the panel open ?? How do you get door open if neither handles work an door is shut ...

[@jfhunt]

I had that problem twice So, I took the bolts out of the door panel, easy. Then, I lifted hard on the panel to raise it to clear the window channel while freeing the upper left corner tabs of the panel. Next, I pulled the upper left panel towards me, reached in to pull the foam liner away from the butyl tape that secures the foam to the steel door. Then, with the window closed, I was able to get my arm into the door space (just barely and ending with a scratched-up arm, but no big deal). I just grabbed the cable going into the actuator, and give it a good tug toward the front of the vehicle. If the cable end is broken loose, you might need to pull the sheath off and pull the bare cable or even reach farther in to move the flipper on the actuator - not sure my arm would be long enough with out using a pick tool Make sure the both the manual and electric locks are NOT LOCKED when you pull on the cable. Well that is the idea and it work twice for me. Don't cut it panel, since it would be no easier IMHO ...

[@joshgallegos8202]

You broke the door panel taking it off sir

[@Bo-Jarrah]

WHAT ARE YOU DOING! LACK OF SKILLS AND YOU DON'T KNOW WHAT TO DO.