√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*
@atye043 жыл бұрын
That egr valve looks a bit rusty.
@Dave-co1cv2 жыл бұрын
I would suggest using a mini needle-nose plier to remove the piece that broke off in the rubber tube. Also, DO NOT use PB Blaster on rubber tubing unless you don't mind destroying the rubber. Use 100% silicone. You can also use o-ring grease like commonly used in swimming pool pumps. Other lubricants can react with and "eat" rubber.
@pappynotpapi20703 жыл бұрын
I replaced this on my 2002 mustang (v6) and it wouldn’t start afterwards, so I had to put the old one back on, but I still have the check engine light. Any tips?
@dianepittsbritt69453 жыл бұрын
I've got a 2003 ford taurus; on the back side of the engine there's a part that has melted, and it being messed up makes the exhaust very loud; there are two holes where the hoses go in, and it sucks air, if I put my finger on the holes the exhaust gets quiet; what is this part called...?? Help!!
@keithinblunt78427 ай бұрын
Is that DPF sensor
@dannyprice52192 жыл бұрын
The dpfe on my 2002 focus mounts the same way. but it looks like the mounted type without the bolt holes, with the oblong connector. I can’t use the cheaper part because their connections aren’t the same. What was Ford thinking?
@cp14075 жыл бұрын
Would a 2017 Mazda CX 5 be too new to do any simple videos on? Thanks.
@realjaxon3 жыл бұрын
Where is this part located on a '02 Duratec DOHC 3.0LTaurus ?
@1AAuto3 жыл бұрын
+therealjaxon You can usually locate the EGR valve pressure sensor on the firewall of the vehicle. The pressure sensor is normally near the center, between the master brake cylinder and heater hoses on the firewall.
@jessecanales90005 жыл бұрын
No diagnosis???
@bweather043 жыл бұрын
That's what I was wondering. A bad sensor reads 1v. A good one should read below 0.6v
@musicsubicandcebu17744 жыл бұрын
thanks
@1AAuto4 жыл бұрын
+Music Subic and Cebu Thanks for checking us out! 1aau.to/m/Shop-1AAuto-c