HOW TO REPLACE FORD KA/ Fiat 500 LOWER FRONT SUSPENSION ARMS BOTTOM BALL JOINTS

Guess who's back, back again.... Jim is back, so tell your friends!
guess who's back, guess who's back guess who's back.....
In this video ill show you how to replace those pesky lower arms on the ford ka/ fiat 500 you own!
lovely.
-----------------------------------------------------------------------------------------------------------
*All video/images remain my property and must not be re used or copied without my prior permission!

[@surfin4181]

This was very helpful , thanks a lot. I just would like to meet the responsible engeneer to kick bis as..

[@TheHappysacker]

Thanks for the time you put in to this.

[@garyoncaravanning7608]

Cheers! Just used your video to change the one on my daughters car. Very helpful

[@christophemontheil4933]

thank you so much from France for this clip.Very usefull !!!

[@gilly51449]

Brilliant mate thank you so much for this video 👍😁 massive help

[@moshazza5684]

What are the torque specs for the 2 main bolts on control arm and the pinch bolt on the ball joint thanks

[@thefunnyclubkids5518]

What exact tools do I need for this please? Sizes etc? Thank you

[@07162]

Can anybody tell me the Nm for all of those Screws

[@thefunnyclubkids5518]

What exact tools do I need for this please?

[@wholebarto]

Yesterday I did in my Fiat 500. It took me about 4 hours and saved some money and, as a result, all knocks and different noises went away. I had a problem with washer reservior bolts which were corroded and broke while unscrewing them.

[@stdavidboy]

Fiats never change, little rotters !

[@BeerboxRider]

Hi, nice video! It helped me a lot. But how did you get the arm out without removing the stabilizator? It’s blocking me from pulling it out :(. I’d be grateful for some advice :)

[@DerGolf2000]

Loosen the link on the opposite side also....then you can move it out of the way...

[@TheBurnoutdeluxe]

Hey dude, nice how to... But you forgott to mention that the front bolts of the arms should be tightened at driving hight of the car, so the bushings will last 10 times longer ;)

[@ALLTHINGSJIM]

That is very true, I do mention to do that in my other lower arm videos, thanks for pointing that out👍

[@mackingj6500]

Removing the water bottle not needed neither do you nee to remover the cross member to do this, yeah it gives you more room but unnecessary

[@jerome_karxx]

thanks !

[@ALLTHINGSJIM]

Not a problem, thanks for commenting!

[@jerome_karxx]

ALL THINGS JIM , good job, i will try to do it this Week, and after the timing belt , if you can post a video :-)

[@ALLTHINGSJIM]

jerome karxx no problem, subscribe! Look down my videos list there is already a cambelt replacement video for this engine ;-)

[@jerome_karxx]

ALL THINGS JIM ok super ! I will save Time ..

[@Bakersvill]

Do you seriously have to take half the car apart for that!

[@ALLTHINGSJIM]

Yes, its a pants design! 👍

[@stdavidboy]

I couldn't believe it either!!! Pathetic design

[@carlsherwin5557]

@@ALLTHINGSJIM best place for fiat's is the scrap yard😁

[@TheHappysacker]

is this a pig of a job to do on Axle stands?

[@ALLTHINGSJIM]

To me everythings a pig on axle stands 😂

[@stdavidboy]

What a crap design?