how to replace front brake pads rotors 2013 mercedes c300 4matic {awd} brake pads rotors replacement

[@Depression2010]

Thanks for the video. I watched it before changing my brakes this morning.

[@TerryCunningham-j2i]

Thanks for the video! Goings to do my brakes and rotors tomorrow!!!

[@JM-AUTO]

great, I appreciate it, thanks for sharing.

[@Alexash029]

What’s that tool called ? The one you used to put in the metal break pad clips

[@JM-AUTO]

it is a brake caliper piston spreaded but it is not that strong, only for small things like that but some how it has helped me for other pusposes.

[@TEW1157]

I always though that opening the master cylinder cap to relieve any pressure from compressing the caliper was needed as a general rule. We don't need to do that?

[@JM-AUTO]

you can do it but if every thing goes normal then you don't need it at all

[@baldricpagan3456]

Btw, what rotors are they for the front and back?

[@Depression2010]

The easiest way to get off a stuck wheel on the front of a vehicle is to loosen all the lugs and remove all but 2 leave last 2 barely in place a block of wood between tire and frame and turn your steering wheel.

[@JM-AUTO]

Beautiful it is great to share ideas thanks

[@JM-AUTO]

Thanks for your comment

[@baldricpagan3456]

what type of grease was it again?

[@eddielam389]

You can use copper Anti Seize for Rotors. Nut Don't put because very dangerous

[@intensav8241]

it is not safe to put anti seize on the bolts... they can unmount with vibration.. you should clean them and add some thread locker...

[@blisback]

Thank you very helpful

[@JM-AUTO]

thank you I appreciate it.

[@congoparrot]

WHY NOT USE THE FRONT JACK POINT THEN PUT YOUR JACKSTANDS ON THE SIDE JACKPOINT?

[@richpimentel1841]

Just changed my front break pads. The brake pedal sinks to the floor. Any suggestions? 😟😟

[@congoparrot]

I INOW YOU POSTED THIS 11 MONTHS AGO, THIS IS NORMAL SLOWLY PUMP YOUR BREAK PEDDAL UNTIL YOU BUILD PRESSURE BACK UP. ^^ DO NOT SINK YOUR PETTLE TO THE BOTTOM OR YOU WILL FUCK UP YOUR MASTER CYLENDER.

[@waqasarif3149]

Can you please share the size of the rotors?

[@JM-AUTO]

yes I can, rotor size: 322x32mm, discard thickness 30mm(1.18in), high 65mm(2.6in. thanks for coming to my channel.

[@groovyruben7776]

You just kick the top it has a lock lol

[@tsebanks3988]

The top Nut on my bracket was so tight I can’t get it to break loose for shit other than that this would have been easy an quick

[@JM-AUTO]

yes some times this happens but im sure you will do a great job and thanks for the visit.

[@Playplayab]

Wrong rotors no?

[@JM-AUTO]

No they are not wrong other wise they are not going go fit. Thanks for your comment Abner