How to replace gearbox 4x4 transfer box switches on Nissan Navara D40

[@brendonmccubben8927]

Abs faults will prevent 4wd engaging in d40. Check abs sensors, usually the rear sensor cables are damaged as they are exposed to debris. The abs light on your dash indicates this is the problem. I had a similar issue with mine. However my fault was the actual abs controller

[@philippos6290]

Mine finally fixed. A Nissan dealer here in Cyprus wanted €95plus vat for each switch which that makes €452+transfer oil €52+labour €170.total€684. I fixed it with around€250.bought the swithces from Minsk Belarus.I just bought the transfer oil from here.And the problem was 1 of the switches but i replace them all.

[@L663]

Hi - i think it generally a good idea to replace them all - the money you save on garage labour and the time to take it to the garage etc - better to replace all switches and then you know you are all good. How many switches did you replace ? 3 or 4 ?

[@philippos6290]

Hi mate.i bought all 4 swithes but i replaced 3 on transfer box.when i saw that it was fixed then didnt bother to replace the other one.But anyway i didnt knew where was the 4th switch located.Do you have any idea wheres it it?on gearbox? Keep in mind that mine is auto. Cheers mate

[@sn8kest]

That flashing is telling you to turn the wheel to about 3 o’clock to engage 4x4

[@danielb6841]

Is there a follow up video to this?

[@waynelunjevich429]

Hi my 4wd light stays on even when in 2wd. I need the change actulator up by front axles? Still looking for part and costing. Do you know where to purchase it and how much?

[@arthurhendley4167]

I have an 05 frontier. It will only pull in 4 low. It can't go into 4 high or 2 high. It just acts like neutral unless I get it in 4 low. Do these switches cause that if they're bad?

[@311mdub]

Thank you mate! Been getting loads of snow here in Utah, USA, and have been needing my 4wd! 4wd light kicks on, the little icon in the rpm guage shows it’s activated yet nothing! Great help thanks again!

[@francispamintuan842]

Hello what kind of oil or type of oil are you using to the transfer case box and what the capacity?

[@ngochuybk]

Hi, Do you have the same video for Nissan pathfinder R51? I dont know how to replace the switch at the top of the transfer case. How do they remove it? remove transfer case to take the switch ? Thanks

[@L663]

Sorry, no

[@jojivunuqa9814]

I have a vq40de engine and the 4wd light not appearing from the dashboard can you help me from this?

[@Jacksonransom]

Replace both transfer case relays under the hood

[@chrissmith3222]

where is the link for hte next video i have the smae problem no one seems to be able to fix it

[@Sroor90010]

Yep where is the next video 🤔

[@drummerjim67]

Very informative video. I see how you removed the switches. I have a '08 Xterra (US vehicle). My question is how to you remove the clips that are attached to the switches? - Thanks.

[@haseebjannhaseeb6704]

Wawa

[@colinm610]

Did you have to have the main shift selector in 'neutral' for a start (park will not engage until the vehicle moves). ABS light issue won't help either. You can hear it selecting 4L or 2WD if you listen.

[@L663]

You may be correct !

[@colinm610]

@@L663 I didn't have an owners manual as I bought mine 2nd hand. I had to work it out. It was pretty confusing. If you change it from 2WD to 4L while in neutral (which is best) make sure you put your foot on the brake at the same time even if you are on a flat surface. If you do it while in park you will have to drive forward a bit or reverse it if that doesn't work - even a few times. LOL. It's the same if you are going from 4WD back to 2WD.

[@naymis]

Hello, good video thank you. What is the Allen key size at minute 10:56 for empty ATF ?

[@jacojansevanvuuren5812]

Thanks man your advise worked great tested the switches and 2 was faulty cleaned them working great... But i saw some water on switches A and B is it normal.. Thanks jaco

[@gary798]

Gday mate can i get the link to the website please as i need the transfer box switches for my D40.. cheers

[@selmakimora]

My nissan pathfinder 2005 dci automatic only driving in 3rd gear. Speed reduces and Il have to switch off and start again. Also struggling to Pull or drive when switching on

[@galaxydefender1033]

did you remove the oil? before removing the switches? i was not clear on that.. I imagine you drained it.

[@L663]

No we did not drain !

[@galaxydefender1033]

@@L663 i don’t understand how that thing works. I thought the oil would come pouring our.

[@leejohnson2k]

Your Abs light is on hence why your 4wd won't work

[@ngochuybk]

Hi, you should show how ot unplug the B. I couldn't do that.

[@bendodwell5225]

I’m having the exact same problem. Did you get a fix ?? Where do I buy the switches ?? 2005 N Navara.

[@bradleyrodgers8301]

Whats the link for next video as ita because of your abs

[@dantemolonlabe1090]

Any advice where to get the plastic connector, from wiring harness, that plugs onto the switch labeled B? Tks.

[@pricealadeen170]

Also need this wondering if u found them

[@wanmarang6539]

sir,navara d40 code p1817 when i push break,4wd linght on, how can i do sir, thanks sir🙏🙏

[@alexandrugarboan2010]

Hi, I have a nissan pathfinder 2006 manual gearbox diesel engine can you provide me with the switches. Thanks, Alex

[@philippos6290]

Hi guys.i ve got the same problem with my 2011 Navara tekna auto. What was the problem finally?

[@a1079548]

Mine wouldn't engage because the ABS light was on - Looks the same in this video

[@philippos6290]

James Taylor thanks mate.As you can see mine had a faulty switch finally fixed.

[@francispamintuan842]

Where is the next video? May i see what is happen

[@markklinkert3477]

Help please. Mine goes into 4 by 4 but won't go into 4lo. I've just found that I have a p1814 code. I've replaced the 3 switches, checked the relays, physically turned the selector to 4by4 and 4 lo (so the transfer case is moving). I've also switched it into 4by4 using the switch and the actuator does turn but it doesn't turn when selecting low. I've stripped the actuator and it all looks very healthy. I've replaced the transfer case oil. I've also used live diagnosis and seen the switch pics up 4lo..... broken wire?

[@L663]

Sorry I am not sure what the solution to this one is - sounds like you are doing all the correct things.

[@markklinkert3477]

@@L663 cool. Thanks for the reply though. If I find out I'll let you know

[@Iaminbread]

Do you have an automatic gearbox.? It will only go into 4 flow if you have the drive in neutral.

[@zevitu3692]

friend, did you find out what was the problem with your nissan?

[@zevitu3692]

friend, did you find out what was the problem with your nissan?

[@ArnulfoMartínezVargas-n5o]

Unas tardes como puedo pedir la pieza en AutoZone creo se me daño el A

[@galaxydefender1033]

i changed my switches and it flashes different and still does not work properly... they 4x4 works.. but it does not shows it properly on the dash

[@Sroor90010]

The 4wd display is not showing its blank so what it could be no display on instrument cluster 😵

[@WOOD4EVER]

Abs man is lighting

[@bacanualex8930]

All three are working in the same way? When there are press? I have one that works when its realeased, its normal?

[@L663]

Hi - this is a good question and i am not sure - some may be normally open and others normally closed.

[@bacanualex8930]

@@L663 “a” and “b” are normaly closed and “c” its open, its ok?

[@bradleyrodgers8301]

That is correct with the one closed

[@bacanualex8930]

@@bradleyrodgers8301 so they must work when they are closed/pressed? All of them?

[@blackztone101]

Thank you great tutorial.

[@plamenm1641]

Did you fixed it, mate? what;s the end of story?

[@dannmoncada2615]

Mi nissan paifander 2008 apago la pantalla donde flachean las llantas y la transición y no camina

[@deepbluewaterful]

man, abs, plus youhave to reset on comp after switch change

[@SalhiAbdelkader-n5c]

عندي مشكلة عدم عمل 4lo نيسان نفارا

[@patriciaiyanez1755]

Tengo problema con mi navara con la 4x4 y nadie puede solicitarme el problema

[@dannmoncada2615]

Necesito un consejo q puedo hacer

[@kermets]

cool, if you flick you meter one click CCW you wont need to look at the meter as it will Buzz

[@L663]

but i,m deaf !....not really good point

[@raymondjoanes86raymond]

Tq bro...

[@alanorlandoalvarado2785]

Devian de aser en español tanvien digo yop

[@ashknaniroyal5139]

You have a problem with ABS So it doesn't work well

[@davidav8orpflanz561]

Funny seeing the steering wheel on the wrong side, eh!

[@L663]

Is there are problem with your computer ? maybe your monitor has reversed the picture ? I can assure you the steering wheel is on the correct side !

[@dannmoncada2615]

A TP vDc

[@davidhanning8649]

pay atation to truck not idiot lights

[@edmargueno7425]

Tem português

[@uchoapinheiro74]

Traduzir para português

[@onewaycabtaxicabhier4491]

Kuv100 Kam 00000 CNG

[@mr.dhanjitrai9335]

stupid ,,story

[@L663]

Hi Raj - I hope your having a good day ! Sorry my video did no meet your expectations.. can you give me any idea how i can make it better? thanks for your feedback.