How To Replace Jeep Wrangler Transfer Case Output Shaft Seal

[@ziadajam5433]

I kept seeing fresh oil drops under my jeep thinking it was motor oil until I realized it was further back then the motor, took a closer look and seems like I need a new output seal. Thanks for the help. Informative video

[@HomeOwnerRepair]

Thanks for watching.

[@HomeOwnerRepair]

If you have any questions about this video or the procedure post here

[@frankoneyjr.4515]

I would remove the rear housing and replace the seal and the bushing inside the housing. Complete job done and no more leaks !

[@HomeOwnerRepair]

Thanks for watching

[@justinchapman9637]

Thanks for the video!

[@HomeOwnerRepair]

Thanks for watching

[@tdg0101]

Thanks for the video, where did you get seal or what brand is it?

[@HomeOwnerRepair]

I purchased it from Rockauto.com Check them out they should have one for you.

[@russwilson2182]

when you mentioned a socket or something to hammer the seal in, you want it to be inside the rim or does it have to be on the outside lip?

[@HomeOwnerRepair]

It should be somewhat flush as shown in the video.

[@leakyjeep5.9]

Inside the rim is preferred and doesn't hurt anything. I think grabbed a 1.75" one from AutoZone and banged it in perfectly.

[@patrickmacgonegal]

Great job. So, it has been a couple years- is that seal still holding?

[@HomeOwnerRepair]

SO far so good

[@MrMGutierrez84]

No nicks, it’s a pretty good amount of fluid leaking out. I pulled the transfer case to inspect it better.

[@HomeOwnerRepair]

That sucks..let me know how you make out

[@Texaca]

hello, is the an Automatic or a Manual transmission, 2) is this the same procedure for a transmission that does Not have a transfer case. fyi, I have an AX-15 5-speed transmission, a 2x4 unit

[@HomeOwnerRepair]

It may be a different procedure

[@hesokayegar8259]

I tried to replace it just like what you did but it fought me so hard I ended up removing the housing to work on better Now the problem is that the housing did not come back on perfect bolts did not align with holes could I did it wrong Please I need help

[@HomeOwnerRepair]

I currently do not have a video that shows how this god back together

[@jasonbaker5466]

I have an np231 and the slip yoke broke on the output, can I just pull on the broken yoke and it should slide out?

[@HomeOwnerRepair]

Depending on how it broke it may just slide out

[@MrMGutierrez84]

I’ve replaced seal twice and there is still a leak. Any idea of what it might be?

[@HomeOwnerRepair]

You may want to check for a nick in the case where the seal presses in. If there is a nick or gouge it might leak a little.

[@leakyjeep5.9]

This is why people use a bit of rtv around the outside..

[@pickles1926]

One has the

[@HomeOwnerRepair]

Thank you for watching our auto repair video that shows you how to replace the transfer case seal on a Jeep Wrangler YJ.

[@frankoneyjr.4515]

Hesoka ! It came off soit has to go back on ! Jusrotate it till the hoes line up ! Drain hole shouldend up on the bottom !

[@HomeOwnerRepair]

Thank you for watching our auto repair video that shows you how to replace the transfer case seal on a Jeep Wrangler YJ.